cisco packet tracer 8.2.2 (思科模拟器) 配置 单臂路由 DHCP

1 实验拓扑

2 交换机配置

Switch>
Switch>en
Switch#sw1
Switch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#hostname sw1
sw1(config)#vlan 2
sw1(config-vlan)#exit
sw1(config)#vlan 3
sw1(config-vlan)#exit
sw1(config)#int  gigabitEthernet 1/0/1
sw1(config-if)#switchport mode access 
sw1(config-if)#switchport access  vlan 2
sw1(config-if)#exit
sw1(config)#int  gigabitEthernet 1/0/2
sw1(config-if)#switchport mode access 
sw1(config-if)#switchport access  vlan 3
sw1(config-if)#exit
sw1(config)#int gigabitEthernet 1/0/3
sw1(config-if)#switchport mode trunk 
sw1(config-if)#no shut
sw1(config-if)#end
sw1#w
Building configuration...
Compressed configuration from 7383 bytes to 3601 bytes[OK]

3 路由器配置

Router>en
Router#config t
Router(config)#hostname r1
r1(config)#