Scribd
Upload
17 views

Corrosion Repair Application Note 5

The document describes a pipeline repair project involving a 2-inch carbon steel pipe carrying condensing water. The pipe was experiencing galvanic corrosion at welding joints. A cost-effective and permanent solution was needed to withstand 350 psig pressure. SealXpert's Wrap Seal PLUS corrosion repair system and Seal Stic steel epoxy were used. First, epoxy was applied to repair pitted areas, then activated resin was coated on. Fiberglass repair tape was applied for reinforcement. The repaired pipe withstood pressures after the project.

Uploaded by

Engr. Erwin Olivares
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views

Corrosion Repair Application Note 5

The document describes a pipeline repair project involving a 2-inch carbon steel pipe carrying condensing water. The pipe was experiencing galvanic corrosion at welding joints. A cost-effective and permanent solution was needed to withstand 350 psig pressure. SealXpert's Wrap Seal PLUS corrosion repair system and Seal Stic steel epoxy were used. First, epoxy was applied to repair pitted areas, then activated resin was coated on. Fiberglass repair tape was applied for reinforcement. The repaired pipe withstood pressures after the project.

Uploaded by

Engr. Erwin Olivares
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Block 3007 Ubi Road 1, #06-422 Singapore 408701 Tel: (65) 6747 1527 Fax: (65) 6747 6547

Email: [email protected] Website: www.sealxpert.com

SealXpert Products
Corrosion Repair Application Note 5
Pipe Material: Pipe Medium: Pipe Pressure: Temperature: Nature of Corrosion: Pipe Length: 2 Carbon Steel Pipe SCH40 Condensing Water 350 psig 30C Galvanic corrosion 50 meters

The condensing water pipe has galvanic corrosion at the welding joints on all branch pipes. The customer requires a cost-effective and permanent solution that can withstand the 350 psig operating pressure. Wrap Seal PLUS corrosion repair system and Seal Stic steel epoxy was used together to perform TM pipeline repair and rehabilitation in this project. First, Seal Stic steel epoxy was applied to built up the pitted TM TM area, then Wrap Seal PLUS activated resin was coated onto the pipe surface. Lastly, Wrap Seal PLUS fiberglass repair tape is applied onto the coated pipe for reinforcement. Application Photographs
TM TM

Galvanic corrosion at weld joint

Galvanic corrosion at weld joint

Applying Seal Stic

TM

steel epoxy

Applying Wrap Seal PLUS

TM

fiberglass repair tape

Pipe condition after repair with Wrap Seal

TM

PLUS

Pipe condition after repair with Wrap Seal

TM

PLUS

Expert in Pipeline Products

You might also like