0% found this document useful (0 votes)
109 views

Vehicle Control System

The document provides instructions for removing and inspecting an ignition or starter switch assembly on a Toyota Avensis. It outlines the three steps to remove the switch: 1) remove the lower steering column cover, 2) remove the upper steering column cover, 3) disconnect the connectors, remove the clamp, and unscrew the bolt holding the switch in place. It then describes inspecting the switch resistance by checking between terminals and comparing to specifications, replacing the switch if resistance is not within standards.
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
109 views

Vehicle Control System

The document provides instructions for removing and inspecting an ignition or starter switch assembly on a Toyota Avensis. It outlines the three steps to remove the switch: 1) remove the lower steering column cover, 2) remove the upper steering column cover, 3) disconnect the connectors, remove the clamp, and unscrew the bolt holding the switch in place. It then describes inspecting the switch resistance by checking between terminals and comparing to specifications, replacing the switch if resistance is not within standards.
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

801

VEHICLE CONTROL SYSTEM IGNITION OR STARTER SWITCH ASSY

IGNITION OR STARTER SWITCH ASSY


8002704

REPLACEMENT
HINT: The installation is in the reverse order of the removal. 1. REMOVE STEERING COLUMN COVER LWR (See page 509) 2. REMOVE STEERING COLUMN COVER UPR (See page 509)

3. (a) (b) (c)

REMOVE IGNITION OR STARTER SWITCH ASSY Disconnect the ignition switch and unlock warning switch connectors. Remove the clamp. Remove the screw and ignition switch.

F44171

AVENSIS REPAIR MANUAL (RM1018E)

802
VEHICLE CONTROL SYSTEM IGNITION OR STARTER SWITCH ASSY
8002804

INSPECTION

LOCK

55_ ACC 35_ ON 35_ START

1. (a)

INSPECT IGNITION OR STARTER SWITCH ASSY Inspect the switch resistance. Standard:
Terminal No. 23 13 23 46 13 45 46 START ON Below 1W Switch Condition ACC Specified Condition

B68363

If the result is not as specified, replace the switch.

AVENSIS REPAIR MANUAL (RM1018E)

You might also like