Scribd
Upload
37 views

Jawaharlal Nehru Technological University, Anantapur

This document is a project report submitted to Jawaharlal Nehru Technological University in partial fulfillment of the requirements for a Bachelor of Technology degree in Electronics and Communication Engineering. It describes the development of a high sensitivity intelligent blind stick to help blind people detect obstacles. The device uses infrared transmission and reception along with signal processing and amplification circuitry to drive a buzzer alert when obstacles are near.

Uploaded by

mahi07404
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
37 views

Jawaharlal Nehru Technological University, Anantapur

This document is a project report submitted to Jawaharlal Nehru Technological University in partial fulfillment of the requirements for a Bachelor of Technology degree in Electronics and Communication Engineering. It describes the development of a high sensitivity intelligent blind stick to help blind people detect obstacles. The device uses infrared transmission and reception along with signal processing and amplification circuitry to drive a buzzer alert when obstacles are near.

Uploaded by

mahi07404
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 12

HIGH SENSITIVITY INTELLIGENT BLIND STICK

A Mini project report submitted to Jawaharlal Nehru Technological University, Anantapur in partial fulfillment of the requirements For the award of the degree BACHELOR OF TECHNOLOGY in ELECTRONICS AND COMMUNICATION ENGINEERING
A.FAYAZ A.MANJUNATH B.LINGA SWAMY K.PURANDHAR KUMAR T.S.KHAJA HUSSAIN (092G1A0405) (092G1A0401) (092G1A0416) (092G1A0429) (092G1A0455)

Under the esteemed guidance of MS. RADHA .M.Tech HOD Dept Of E.C.E A.L.I.T.S Anantapur

Department Of Electronics & Communication Engineering ANANTHA LAKSHMI INSTITUTE OF TECHNOLOGY &SCIENCES (Affiliated to JNTU ANANTAPUR) ANANTAPUR-515001,A.P 2012

A. FAYAZ

A. MANJU NATH
B. LINGA SWAMY K.PURANDHAR KUMAR T.S.KHAJA HUSSAIN GUIDED BY RADHA

INTRODUCTION BLOCK DIAGRAM WORKING

APPLICATIONS
FUTURE SCOPE CONCLUSION

Accidents occur due to intense traffic for blind people

This is used to facilitate blind people in obstacle detection.

IR TRANSMITTER

SQUARE WAVE GENERATOR

BUZZER

IR RECEIVER

AMPLIFIER

DRIVER CIRCUIT

IR transmitter transmits the detected signal to the generator the generator generates the signal to the amplifier.

The amplifier increases the strength of the signal.


The output amplified signal is driven by the driver circuit. The driver circuit uses diodes resistors and capacitors.

The output of the driver circuit is given to the buzzer which indicates the signa

INSTEAD OF INFRARED WE CAN USE ULTRA SONIC.

CONCLUSION
This project works very well even in night and day times It is reliable and effective

You might also like