0% found this document useful (0 votes)
16 views

AnaSat C-Band Quick Start Guide

Mount the transceiver and the LNC on the antenna. Connect a terminal to a serial port, configured to 1200bps, 8 data bits, no parity, 1 stop bit, CR / LF Off. Plug the cable into 110 or 240VAC, 50 / 60Hz.

Uploaded by

Techne Phobos
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
16 views

AnaSat C-Band Quick Start Guide

Mount the transceiver and the LNC on the antenna. Connect a terminal to a serial port, configured to 1200bps, 8 data bits, no parity, 1 stop bit, CR / LF Off. Plug the cable into 110 or 240VAC, 50 / 60Hz.

Uploaded by

Techne Phobos
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ANACOM

ANASAT -C Quick Start Guide


There is a lot more inside the manual, but here are the most important steps:

3072309

1. Mount the transceiver and the LNC on the antenna. 2. Connect the cables as shown in the drawing (See page 2-3 of Operations Manual). 3. Connect a terminal to a serial port, configured to 1200bps, 8 data bits, no parity, 1 stop bit, CR/LF Off. Connection diagrams are in Appendix C. 4. Install a proper power connector on the (included) power cable. Plug the cable into 110 or 240VAC, 50/ 60Hz. Verify the green LED on the transceiver is blinking, indicating normal internal operation. The red LED is usually OFF. If illuminated, it indicates an alarm condition requiring attention. Refer to the ALARM command for details (Appendix A). 5. Using the terminal, configure the transceiver to the proper frequency: RXFREQ nnnn (nnnn in MHz see Appendix D for channel) TXFREQ nnnn (nnnn in MHz see Appendix D for channel) 6. Configure receive gain and transmit output power: RXGAIN nnn nnn ranges from 85 to 100 TXGAIN nn nn ranges from: 10 to 36 [0C] 44 to 70 [2C] 48 to 74 [5C] 51 to 77 [10C] 54 to 80 [20C] 57 to 83 [30C, 40C] 58 to 84 [50C, 60C] 60 to 86 [70C, 80C] 61 to 87 [100C] 63 to 89 [150C] 7. Enable the Transmitter: 64 to 90 [200C] TX ON (TX OFF takes the transmitter OFF air)

Thats really all you must do! Good luck with your new ANASAT -C Transceiver! September 2008 ANASAT C Transceiver

You might also like