Scribd
Upload
394 views

Lattice

Lattice girder slabs provide reinforcement for concrete slabs. They consist of a lattice of steel bars arranged in a grid pattern within the slab. The document discusses design considerations for using lattice girder slabs in different construction applications, including masonry, steel frame, and precast concrete structures. It also outlines typical reinforcement bar sizes and spacing used in lattice girder slabs.

Uploaded by

nrnnadig
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
394 views

Lattice

Lattice girder slabs provide reinforcement for concrete slabs. They consist of a lattice of steel bars arranged in a grid pattern within the slab. The document discusses design considerations for using lattice girder slabs in different construction applications, including masonry, steel frame, and precast concrete structures. It also outlines typical reinforcement bar sizes and spacing used in lattice girder slabs.

Uploaded by

nrnnadig
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Lattice Girder Slabs

Data sheet Lattice


May 2009

Earls Colne Business Park, Earls Colne, Colchester, Essex, CO6 2NS Tel: 01787 223931 Email: [email protected] Email: [email protected]

Typical Lattice Girder Slab


25mm side bearing

60mm minimum bearing

<60mm bearing

Bearing on masonry wall more than 60mm

Bearing on masonry wall less than 60mm


Temporary prop

Side Bearing

Composite Floors in Masonry Construction

Support on shelf angles

Nominal bearing over 55mm (otherwise temporary prop)

Support on top flange

Composite Floors in Steel Frame Construction

8-16mm dia top bar

4.5-7mm diagonal s 5mm dia bottom bar s

65mm minimum bearing on formwork

Composite Floors in Precast or Insitu Construction

Lattice Girder Detail

Insitu concrete by others Mesh or loose bars over panel joints Mesh* Total slab depth Milbank Lattice Girder Slabs Typical cross section 225 - 300mm 160 - 200mm < 150mm Total Slab Depth Spacing of lattices to suit individual design loadings

Standard 2400 wide slab

Minimum mesh to BS4483* A 393 A 252 A 193

All additional reinforcement to insitu zone, Mesh loose bars etc to be supplied and placed by Main Contractor

Lattice Girder Slabs

End restraint reinforcement where requried Mesh*

Continuity reinforcement in top of slab where required

s pan

End span anchorage reinforcement Continuous head trees on props as specified Typical longitudinal section

Anchorage reinforcement over panel end joints

May 2009

Data sheet Lattice

You might also like