0% found this document useful (0 votes)
403 views

Tutorial 5

This document contains multiple questions about direct current (DC) motors and generators. It includes questions that ask the reader to determine motor speed, resistance values, and power given various motor parameters like voltage, current, resistance, and load. It also provides answers to some of the questions.

Uploaded by

slim_nitemare
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
403 views

Tutorial 5

This document contains multiple questions about direct current (DC) motors and generators. It includes questions that ask the reader to determine motor speed, resistance values, and power given various motor parameters like voltage, current, resistance, and load. It also provides answers to some of the questions.

Uploaded by

slim_nitemare
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Tutorial #5

4.7. A series motor takes 40A at 460V while hoisting a load at 6m/s. The armature plus field resistance is 0.48 . Determine the resistance to be placed in series with the motor to slow the hoisting speed to 4m/s. Assume linear operation on the magnetization curve. (Ans. 3.67 ) 4.13. A 100KW belt driven shunt generator runs at 600r/min on a 250V bus. When the belt breaks, it continues to run as a motor (supplied by the bus), then taking 8KW. What will be its speed? Armature resistance is 0.02 , and the field resistance is 125 . (580 rpm) 4.14. The figure below shows a dc motor under full-load condition driving a pulley mechanism to hoist an elevator at constant speed. (a) what is the minimum-size motor you would recommend? (17266W) (b) if the line voltage V is reduced to 160V, what would be the speed? (1.98 m/s) (2.2 m/s) (c) with V=120V, RF = 440 , and half-load, what would be the speed?
RA = 0.25 V = 220 V RF = 400

Radius 18 cm 2.2 m/s

800Kg

Full load

4.15. A dc series motor drives an elevator load that requires a constant torque of 180 Nm. The dc supply voltage is 250V, and the combined resistance of the armature and series field windings is 0.65 . Neglect rotational losses and armature reaction effects. The speed of the elevator is controlled by a solid-state chopper. At 60% duty cycle (i.e. = 0.6 ) of the chopper, the motor current is 36A. Determine the speed and the horsepower output of the motor and the efficiency of the system. (25.32 rad/s, 6.11hp, 81.5%) 4.17. the speed of a 5hp 250V 900r/min separately excited dc motor is controlled by a single-phase half-wave converter. The armature resistance is 0.42 . The ac supply voltage is 220V. The motor voltage constant is k g = 0.22V / r / min . For a firing angle = 30 o and armature current of 20A, determine the (a) motor speed; (b) motor torque; and (c) power to the motor. (382 rpm) (42 Nm) (1849 W)

You might also like