Scribd
Upload
130 views1 page

Sheet1 DC Machine

The document contains 7 problems about calculating torque, flux, induced voltage, resistance, and speed in DC machines. Problem 1 asks to calculate flux given machine specifications. Problem 2 identifies winding type given machine specs and flux. Problem 3 calculates induced voltage and resistance using coil and machine specs. Problem 4 calculates torque given flux, current and number of conductors. Problem 5 determines if a machine is operating as a motor or generator using voltage, current, speed and torque specs. Problems 6 and 7 calculate additional machine parameters like number of conductors, speed, given various specs like flux, resistance, current, torque.

Uploaded by

Eng_Ahmed_2014
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
130 views1 page

Sheet1 DC Machine

The document contains 7 problems about calculating torque, flux, induced voltage, resistance, and speed in DC machines. Problem 1 asks to calculate flux given machine specifications. Problem 2 identifies winding type given machine specs and flux. Problem 3 calculates induced voltage and resistance using coil and machine specs. Problem 4 calculates torque given flux, current and number of conductors. Problem 5 determines if a machine is operating as a motor or generator using voltage, current, speed and torque specs. Problems 6 and 7 calculate additional machine parameters like number of conductors, speed, given various specs like flux, resistance, current, torque.

Uploaded by

Eng_Ahmed_2014
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Sheet (1) EMF and Torque equations

1. The armature of 2-pole, 200V, wave wound DC machine has 400 conductors and runs at 300 rpm. Calculate the useful flux per pole. 2. A 400V, 8-pole, 600 rpm DC machine has 100 slots. Each slot contains 40 conductors .The flus per pole is 0.01 Webbers .what type of winding is used? 3. A 12-pole DC generator has a simples wave armature containing 144 coils of 10 turns each. The resistance of each turn is 0.011 . Its flux per pole is 0.05 Webbers and it is running at 200 rpm a- what is the induced voltage of the machine? b-what is the resistance of this machine? 4. A four pole lap wound DC machine has 970 conductors .if the flux per pole is 0.06 Webbers and the armature current is 48.6 A. Calculate the torque developed. 5. A DC shunt machine is connected to a 220V supply and is running at a speed of 1200 rpm. , its armature current is 60A and the torque of its shaft is 95 N.m. Show whether the machine is running as a motor or generator . 6. A 4-pole, 500V shunt motor has a simplex lap winding placed in 80 slots, each contains 30 conductors. The shunt field resistance and the armature resistance are 250 and 0.005 respectively. The flux per pole is 0.001 Webbers. The torque developed is 20 N.m. when the motor current is 52A, Determine: a- The number of armature conductors b-The motor speed. 7. A series motor has a terminal voltage of 250V, an armature resistance of 0.023 and has a rated full load speed equals 1200 rpm where the armature current is 62A. Calculate the speed when the armature current is 10A.

You might also like