Scribd
Upload
239 views

Assy of Ball Turner

This document provides instructions for setting up a lathe to turn balls of a desired size. It specifies that the compound rest hole diameter and centers must match the lathe and the distance from the chuck center to the underside of the compound rest. It also states that the dimension should be set to half the desired ball size. The document provides information for a ball turning project.

Uploaded by

António Oliveira
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
239 views

Assy of Ball Turner

This document provides instructions for setting up a lathe to turn balls of a desired size. It specifies that the compound rest hole diameter and centers must match the lathe and the distance from the chuck center to the underside of the compound rest. It also states that the dimension should be set to half the desired ball size. The document provides information for a ball turning project.

Uploaded by

António Oliveira
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

XXX MATCH DIA.

AND THICKNESS OFCOMPOUND REST MOUNT ON YOUR LATHE

ZZZ MATCH HOLE DIAMETER AND HOLE CENTERS ON YOUR LATHES COMPOUND REST YYY MUST MATCH DISTANCE FROM CENTER OF CHUCK TO UNDERSIDE OF COMPOUND REST ON YOUR LATHE

TT SET THIS DIM. TO HALF THE DESIRED BALL SIZE

STEVE BEDAIR BALL TURNER


UNLESS OTHERWISE SPECIFIED
MATERIAL: DESIGNED BY: DRAWN BY:

RUPNOW MACHINE AND AUTOMATION DESIGN 1095 CARSON ROAD BARRIE, ONT. L4M4S5

PART DESCRIPTION

UNITS: ROUGHNESS, Ra:

INCHES 63 MICROINCHES

TOLERANCES
FRACTIONS 1/32

HARDNESS:

BRIAN RUPNOW
PART NUMBER

Tel: (705) 734-6271 Fax: (705) 734-6271 EMAIL [email protected]

REMOVE ALL SHARP EDGES THIRD ANGLE PROJECTION

0.0 .03 0.0000 .005 UNLESS MARKED THEN .0005


ANGULAR TOLERANCES 0 15'

0. 0.00

.05 .01

COATING: CUSTOMER:

ASSY OF BALL TURNER


MASS JOB NO. QTY

SIZE

1:4

SCALE

LAST REV

1/6/2009

DATE PRINTED

SHEET 1 OF 1

You might also like