Scribd
Upload
591 views

Lenton Coupler - Installation Instruction PDF

Installation guides of Lenton reinforcement coupler

Uploaded by

CT0011
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
591 views

Lenton Coupler - Installation Instruction PDF

Installation guides of Lenton reinforcement coupler

Uploaded by

CT0011
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

INSTRUCTION SHEET

LENTON Standard Coupler

in.-lb. #3 #4 --#5 --#6 #7 --#8 --#9 --#10 --#11 #12 --#14 --#18 * Americas

(Metric) Soft Metric (Canada) (10mm) ----(12mm) 13 (10M) (14mm) ----(16mm) 16 (15M) (18mm) ----(20mm) 19 (20M) (22mm) 22 --(24mm) ----(25mm) 25 (25M) (26mm) ----(28mm) 29 (30M) (30mm) ----(32mm) 32 --(34mm) ----(36mm) 36 (35M) (38mm) ----(40mm) ----(43mm) 43 (45M) (50mm) ----(57mm) --(55M) Only

Nm 40 40 80 120 150 180 220 270 270 270 270 300 300 300 300 350 350 350 350 350

ft.-lb. 30 30 60 90 110 130 160 200 200 200 200 200 200 200 200 200* 200* 200* 200* 200*

WARNINGS: 1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your ERICO customer service representative. 2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 3. All instructions must be completely followed to ensure proper and safe installation and performance. 4. Improper installation, misuse, misapplication or other failure to completely follow ERICOs instructions and warnings may cause product malfunction, property damage, serious bodily injury and death. The customer is responsible for: a. Conformance to all governing codes. b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer. c. Using appropriate industry standard hardware as noted above. SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of ERICO International Corporation TECHNICAL SUPPORT: www.erico.com PDF057_C.doc 1 of 1 2005 ERICO, INC.

You might also like