Scribd
Upload
31 views

Falling Blocks

This document provides instructions for making a set of blocks that appear to fall from the top when the first block is tipped. The instructions are: 1) Cut 6 blocks from a thin board and number them 1-6. 2) Attach 3 pieces of tape to block 1 so that when block 4 is placed on top, it will hang from block 1. 3) Attach block 5 the same way so that blocks 2, 3, and 5 are stacked and will fall away when block 1 is tipped. 4) Continue attaching the remaining blocks in the same manner so that the entire stack can fall apart piece by piece.

Uploaded by

Frenchwolf420
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
31 views

Falling Blocks

This document provides instructions for making a set of blocks that appear to fall from the top when the first block is tipped. The instructions are: 1) Cut 6 blocks from a thin board and number them 1-6. 2) Attach 3 pieces of tape to block 1 so that when block 4 is placed on top, it will hang from block 1. 3) Attach block 5 the same way so that blocks 2, 3, and 5 are stacked and will fall away when block 1 is tipped. 4) Continue attaching the remaining blocks in the same manner so that the entire stack can fall apart piece by piece.

Uploaded by

Frenchwolf420
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

392

How to Make Falling Blocks ner, and so on, down to the end.—Con-
tributed by Wayne Nutting, Minne-
Procure a thin board large enough apolis, Minn.
to cut six blocks, 2 in. wide and 3 in.
long; also 2 yd. of cotton tape, .250"

1 4

5 3 2

Set of Blocks Joined with Tape So That


They Appear to Fall from the Top

wide, and some very small


tacks. Cut the board into
pieces of the size mentioned,
and number two of them on
both surfaces, 1, 2, 3, and
4. Cut off three pieces of tape, 4.75"
long, and on the side of block 1 tack
one piece of tape in the center at one
end, and the other two pieces at
each edge on the opposite end,
all being on one side of the block
as shown. Take the other block and
lay the side numbered 4 up, then draw
the two strips of tape on the edges of
block 1 under it and back to the end
of the surface on block 4, and tack them
on this surface at the edges as shown.
The center tape is passed under block
4 and turned over the opposite end and
tacked. This is clearly shown in the
sketch. Thus the second block will
hang from either end of block 1 by
simply folding them together and sep-
arating the ends.
Mark the sides of the third block 5
and 6, and place it with the two others
so that the sides numbered 2, 3, and 5
will be up. Cut off three more pieces
of tape, 4.75 in. long, and tack them
on as shown, being careful not to tack
through any of the first three pieces.
Put on the fourth block in the same
manner as the third block was attached
to the second, and so on, until all the
blocks are attached.
Take hold of the first block on the
edges and tip it as shown by the arrow.
The second block will then fall as
shown by the second arrow, and the
third block falls away in the same man-

You might also like