Scribd
Upload
34 views

Mobile Bug Mobile Bug Mobile Bug

This document describes a mobile phone detector circuit that provides a warning when a mobile phone is used in confidential areas. The circuit uses a CA3130 op-amp integrated circuit to detect radio frequency signals from a mobile phone using a 0.22μF capacitor. When signals are detected, an LED and buzzer are activated by a NE555 timer circuit to alert of mobile phone usage. The detector can be used to prevent phone use in exam halls or confidential rooms from up to 2 meters away, and can detect even silent phones. However, the exact location of the mobile phone cannot be identified due to the limited range.

Uploaded by

Teja Dharma
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
34 views

Mobile Bug Mobile Bug Mobile Bug

This document describes a mobile phone detector circuit that provides a warning when a mobile phone is used in confidential areas. The circuit uses a CA3130 op-amp integrated circuit to detect radio frequency signals from a mobile phone using a 0.22μF capacitor. When signals are detected, an LED and buzzer are activated by a NE555 timer circuit to alert of mobile phone usage. The detector can be used to prevent phone use in exam halls or confidential rooms from up to 2 meters away, and can detect even silent phones. However, the exact location of the mobile phone cannot be identified due to the limited range.

Uploaded by

Teja Dharma
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 11

0

MOBILE BUG MOBILE MOBILEBUG BUG

CONTENTS

INTRODUCTION CIRCUIT DIAGRAM PIN CONFIGURATION OF 1) IC CA3130 PIN CONFIGURATION OF 2) IC2 NE555 WORKING APPLICATIONS LIMITATIONS REFERENCES

INTRODUCTION
AIM:TO CONSTRUCT A CIRCUIT WHICH GIVES WARNING
INDICATION IF MOBILE PHONE IS USED IN CONFIDENTIAL AREAS

WHAT IS AN ORDINARY LC CIRCUIT ?


WHY ORDINARY LC CIRCUIT DOESNOT SUIT FOR CELL PHONE DETECTOR CIRCUIT ? WHAT IS THE BASIS FOR THIS CIRCUIT ?

CIRCUIT DIAGRAM

PIN CONFIGURATION OF (1) IC CA 3130

PIN CONFIGURATION OF (2) IC NE 555 TIMER

WORKING

0.22F Disk capacitor(C3) along with the leads acts as a small antenna to collect the RF signals from the mobile phone

This capacitor creates a field, stores energy and transfers the stored energy the form of minute current to the inputs of IC CA3130
Op-amp IC CA3130 converts the current to corresponding voltage output Capacitor C4 and resistor R1 keeps the non-inverting input (3) stable

in

Resistor R2 provides the discharge path for capacitor C4

Resistor R3 acts as a feed back resistor

C5 is connected for phase compensation


Depending on the signal frequency detected by the C3,output of the IC1 becomes high and low alternatively, indicated by LED1 and beeping of buzzer Mono-stable timer IC2 is triggered through capacitor C7

Capacitor C6 maintains the base bias of transistor T1


R6 and C9 reduce time delay

APPLICATIONS

It can be used to prevent the use of mobile phone in Examination halls, confidential rooms etc. It is also useful for detecting the use of mobile phone for spying and unauthorized video transmission. Range of the detector also plays a important role: EXAMPLE will be explained It can detect the information receiving mobile phone even if it is in silent mode.

LIMITATION
RANGE OF CIRCUIT

The prototype has only limited range of two metres. Exact location of mobile phone cannot be detected

You might also like