Scribd
Upload
84 views

Guida Rti Installazione FW Azbox

The document provides instructions for updating the firmware on an AZBox HD set-top box to Enigma 2 in 7 steps: 1) Copy the patch.bin file to a FAT32 USB drive; 2) Plug the USB drive into the AZBox and power it on; 3) Choose the update from USB option; 4) Wait for the update to finish and note the IP address; 5) Start the AzUP application and enter the IP address; 6) Select options in AzUP; 7) Browse to select the patch.e2 file and wait for the update message, then restart the AZBox twice to complete the process.

Uploaded by

A. Giuseppe
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
84 views

Guida Rti Installazione FW Azbox

The document provides instructions for updating the firmware on an AZBox HD set-top box to Enigma 2 in 7 steps: 1) Copy the patch.bin file to a FAT32 USB drive; 2) Plug the USB drive into the AZBox and power it on; 3) Choose the update from USB option; 4) Wait for the update to finish and note the IP address; 5) Start the AzUP application and enter the IP address; 6) Select options in AzUP; 7) Browse to select the patch.e2 file and wait for the update message, then restart the AZBox twice to complete the process.

Uploaded by

A. Giuseppe
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

TUTORIAL: Official Firmware -> Enigma 2

1. Unpack archive, and copy file patch.bin to USB Memory stick formatted in FAT32 2. Plug-in USB Memory stick in AZBox and turn it ON 3. Choose update from USB 4. Wait that procedure is finished and that on VFD Display You get message Rescue Mode with an IP address, remove USB. 5. Start application called AzUP 2.0.7 6. Enter IP address which is shown on VFD Display of AZBox HD, Device select DOM, FS choose EXT4, Advanced options check two options. For more info look at picture

7. Press GO! button under Install E2/Kernel , then it will ask You for patch.e2 file which is located in folder which You extracted from downloaded Enigma2 archive, choose it and press OK, after that wait until You get message from AzUP.

After first restart receiver will go again to rescue, so restart it once more by long press Power button on remote control or by switching it off and turning on.

You might also like