Scribd
Upload
1K views

Pressure Drop Cal (1) - STD

This document summarizes the pressure drop calculations for a clean Y-type strainer used in a Bombay Chemical Equipment. The calculations determine that: 1) The flow rate is 2777.778 cm3/sec, viscosity is 0.06 gm/cm-sec, and density is 1.137 gm/cc for an acid stream. 2) The element has a 40% opening with a 0.6 mm effective opening size. 3) The calculated pressure drop across the clean element is 0.01 kg/cm2, which is within the required limits.

Uploaded by

prateek_bhoir
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
1K views

Pressure Drop Cal (1) - STD

This document summarizes the pressure drop calculations for a clean Y-type strainer used in a Bombay Chemical Equipment. The calculations determine that: 1) The flow rate is 2777.778 cm3/sec, viscosity is 0.06 gm/cm-sec, and density is 1.137 gm/cc for an acid stream. 2) The element has a 40% opening with a 0.6 mm effective opening size. 3) The calculated pressure drop across the clean element is 0.01 kg/cm2, which is within the required limits.

Uploaded by

prateek_bhoir
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

PRESSURE DROP CALCULATIONS FOR CLEAN CONDITION PAGE 01 OF 01 CLIENT REF. NO.

EQUIPMENT SIZE SERVICE Bombay Chemcial Equipments Y type strainer 80 NB ACID 10 6 1137 400 6 40 40 0.16 63 In m3/hr. In cP. In Kg/m3 In Microns In mm. In % In % 2777.778 0.06 1.137 40 0.6 0.4 0.4 In Cm3/sec. In gm/cm-sec In gm/cc In Mesh In cm.

FLOW RATE() (80,000 cfh) VISCOSITY () DENSITY (r) DEGREE OF FILTERATION OPENING WIDTH (Da) % OPENING IN WIRE MESH (a) % OPENING IN PERFORATED SHEET(g) (6 DIA. HOLE & 9 mm PITCH.) EFFECTIVE OPENING, a = (a x g) SIZE OF ELEMENT (DRG. NO.) GROSS BASKET AREA, A1=(D1L) NET BASKET AREA, A2 = A1 x a VELOCITY n = /A2 REYNOLDS NO. Nre=rnDa/a CO-EFFICIENT OF DISCHARGE (C) (From Perry Page No. 5 40) (Copy Enclosed) PRESSURE DROP 1 1 - a2 V2 __ x ____ x ____ C2 a2 2g PRESSURE DROP ACROSS ELEMENT

16 O.D.In mm(D1) 300

In % Long In mm

59346 9495.36 29.25405438 2078.866239 1.4

In mm2 In mm2 In cm/sec

593.46 94.9536

In cm2 In cm2

8.470603712 9.631076421 0.096310764 0.009631076

cm of Liquid Column cm of Water Column MWC In Kg/cm2

Pressure Drop Required In Clean Condition Is 0.01 Kg/cm2 Since The Actual Pressure Drop Is Well Within Limits.

You might also like