Scribd
Upload
777 views

Multi Phase Star Rectifier

This document discusses a multiphase star rectifier circuit. It has the following key points: 1. It is used for larger output power systems greater than 15kW. It reduces the size of filters by increasing the harmonics in the system. 2. It can be considered as multiple single-phase half-wave rectifiers connected in parallel. Each diode conducts when the voltage of its phase is greater than the others. 3. The primary winding of the transformer must be delta connected to compensate for the DC current flowing through the secondary windings.

Uploaded by

ahmad16_ftua6999
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
777 views

Multi Phase Star Rectifier

This document discusses a multiphase star rectifier circuit. It has the following key points: 1. It is used for larger output power systems greater than 15kW. It reduces the size of filters by increasing the harmonics in the system. 2. It can be considered as multiple single-phase half-wave rectifiers connected in parallel. Each diode conducts when the voltage of its phase is greater than the others. 3. The primary winding of the transformer must be delta connected to compensate for the DC current flowing through the secondary windings.

Uploaded by

ahmad16_ftua6999
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 8

Multiphase star rectifier

By kelompok 2:
Ahmad Candra ( 04 175 016 )
Dodi Candra ( 04 175 0
)
Doni kristian ( 03 175 0
)
Multiphase star rectifier
• For larger (>15kW) output power.
• Harmonics and fundamental
component.
• Filter size decreases with the
increase of harmonics.
• Q phase filter has fundamental
component of qf frequency.
• Also known as star rectifier.
• Filter digunakan untuk mengurangi
tingkat harmonis pada beban
Multiphase star rectifier
• May be considered as q
single-phase half-wave
rectifier.
• K-th diode conducts during
the period when the
voltage of k-th phase is
greater than that of other
phases.
• The conduction period of
each diode is 2π/q.
• Primary must be delta
connected to compensate
the dc component flowing
through secondary
windings.
Assuming a cosine wave from π/q to 2π/q, the average o/p
voltage is. π / q π /q
2 q q π
Vdc = ∫
2π / q 0
V m cos ωt d (ωt ) = Vm
π
sin ωt
0
= Vm
π
sin
q
..... (1)

Output rms voltage is,


1/ 2 1/ 2
 2 π /q   q  ω t sin 2ω t  π / q   q  π 1 2π  
Vrms =  ∫0 m ω ω = Vm   + =  + sin  
2
V cos t d ( t )    m V ..... (2)
 2π / q   π  2 4  0   2π q 2 q 

If the load is purely resistive then peak current through the


diode is Im = Vm/R and the rms current through a diode is,
π /q 1/ 2
 2  (Integrating over the whole period, 2π)
Is =  ∫0 I m cos ωt d (ωt )
2 2

 2π 
1/ 2 1/ 2
 1 π 1 2π  V  1 π 1 2π  Vs
I s = Im   + sin  = m   + sin  =
 2π q 2 q  R  2π q 2 q  R

Vs is the rms voltage of a transformer secondary


Contoh soal
Contoh soal
Contoh soal (lanjt)
TERIMAKASIH

You might also like