Scribd
Upload
73 views

How To Make Tool Box in Solid Works

The document provides steps for using SolidWorks Toolbox Browser to insert machine screws into a part file. It describes opening the Toolbox Browser, navigating to the machine screws folder, and dragging screws into holes where they will mate automatically. Sizes and positions of screws are then set in the Property Manager.

Uploaded by

jaimin100
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
73 views

How To Make Tool Box in Solid Works

The document provides steps for using SolidWorks Toolbox Browser to insert machine screws into a part file. It describes opening the Toolbox Browser, navigating to the machine screws folder, and dragging screws into holes where they will mate automatically. Sizes and positions of screws are then set in the Property Manager.

Uploaded by

jaimin100
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Chapter 11

Boat

A. Enable Toolbox Browser.


Step 2. Click Tools Menu > Add-Ins.

Toolbox Screws

Step 1. If necessary, open your POWER TRAIN ASSEMBLY file.

Step 3. Check SolidWorks Toolbox Browser to place a check in the check box, then click OK, Fig. 1.

B. Design Library.
Step 1. Click the Design Library tab side of drawing area), Fig. 2. Step 2. Expand the Toolbox Expand Ansi Inch folder Expand Bolts and Screws folder Click Machine Screws folder Step 3. In the lower pane, click Pan Slot Head screw, Fig. 2 and drag screw towards screw hole in part. Move the tip of your cursor to the edge of a hole, Fig. 3. When the screw snaps into place and the pointer (cursor) changes to mate, release the screw. concentric and coincident in the Task Pane (right Fig. 1

Step 4. In the Property Manager set Size to #5-40 and click OK Step 5. Continue and place screw in each screw hole, when done. Fig. 3. Click Cancel Step 6. Click the Battery and Hide Step 7. From the Machine Screws (Countersunk) folder place a Flat Head Screw (100), Size #3-56 in Battery Holder hole, Fig. 4. Step 8. In the Feature Manager, click Battery and Show , Fig. 5. Fig. 3 , Fig. 3.

. Fig. 2

Release screw when cursor changes to

Fig. 4

Cudacountry.net Tech Ed http://www.cudacountry.net email:[email protected]

S olid W orks 12 TOOLBOX SCREWS BOAT P age 11-1

Fig. 5

1/26/12

You might also like