Scribd
Upload
13 views

Design of Purlins

The document discusses the design of purlins for a structure. It provides the spacing, length, and load calculations for the purlins, including dead load, live load, and wind load. Bending stresses are then calculated and compared to allowable stresses to determine that the design is safe.

Uploaded by

Divyesh Mistry
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
13 views

Design of Purlins

The document discusses the design of purlins for a structure. It provides the spacing, length, and load calculations for the purlins, including dead load, live load, and wind load. Bending stresses are then calculated and compared to allowable stresses to determine that the design is safe.

Uploaded by

Divyesh Mistry
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Design of Purlins Angle of Purlin with Horizontal = Purlin spacing = Length of Purlin along x-x ; Lx-x = Length of Purlin

along y-y ; Ly-y

SAFE 10 1 5 2.5 m m m

5000 2500

mm mm

Load Calculation a. DL Wt. of sheeting = Assuming ISMC 100 Self Wt = 0.1 KN/m2 b. LL LL on Sheeting = DL + LL = 1.6 KN/m

0.75 0.1

KN/m2 KN/m2

0.75

KN/m2

Resolving the DL+LL into components along x-x and y-y Load x-x Load y-y = = 0.277872743 1.575686117 KN/m KN/m

c.WL Wind Pressure = Positive wind coefficient = WL on Purlins = TL x-x = TL y-y = Mx-x = My-y = Section Properties Area = Zx-x = Zy-y = rx-x = ry-y = slenderness ratio x-x slenderness ratio y-y Allowable Stress x-x= Allowable Stress y-y= Stress Developed x-x = Stress Developed y-y = Maximum bending stress = Maximum allowable = Hence the design is SAFE 0.3645 0.28 1.940186117 6.063081615 0.21875

1.215 0.3 KN/m KN/m KN/m KN-m KN-m

KN/m2

6063081.615 218750

N-mm N-mm

1220 37300 7500 39.67 14.79 126.0398286 169.0331305 59.77 37

mm2 mm3 mm3 mm mm

N/mm2 N/mm2 162.549105 29.1666667 191.715772 219.45 N/mm2 N/mm2 N/mm2 N/mm2

You might also like