Scribd
Upload
20 views1 page

Lab Assignment # 9 Objective: Feedback Control of Thermal System at The Mid of The Steady-State (Of Open Loop) Temperature Range

This lab assignment involves implementing feedback control of a thermal system using proportional on-off control. Students are asked to: 1) Design a unity feedback control loop using a thermal plant model with input voltage proportional to set point temperature. 2) Simulate the control system in MATLAB while varying the load and controller gain to observe their effects. 3) Demonstrate the simulated operations practically in the lab and discuss observations and results.

Uploaded by

Anb Bajwa
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
20 views1 page

Lab Assignment # 9 Objective: Feedback Control of Thermal System at The Mid of The Steady-State (Of Open Loop) Temperature Range

This lab assignment involves implementing feedback control of a thermal system using proportional on-off control. Students are asked to: 1) Design a unity feedback control loop using a thermal plant model with input voltage proportional to set point temperature. 2) Simulate the control system in MATLAB while varying the load and controller gain to observe their effects. 3) Demonstrate the simulated operations practically in the lab and discuss observations and results.

Uploaded by

Anb Bajwa
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

LAB ASSIGNMENT # 9 Objective: Feedback control of thermal system at the mid of the steady-state (of open loop) temperature

range.
In this experiment you implement a feedback control system design for your Thermal System, developed in Lab # 8. Take Set-Point as Tin = 0.5* Tss achieved in your system.

Tin C
Step

K
ON-OFF Gain Control

s s-1 +1)
First Order Thermal Plant Plant

11

Tout C
Scope

Figure 9.1: Feedback loop proportional control of thermal system.

TASKS
(I) (II) Chose Vin (Volts) = Tin * Kh = Tin *0.10 V/C, this will realize unity feedback system. Implement unity feedback ON-OFF control system and simulate it on MATLAB. Add LOAD in the output and set values TLoad C = [1 10 50 100], and observe its effect. (II) Change (increase Kc from 1) and observe and record the simulation results. That is for, Kc = [1 5 10 100] and see how steady-state flickering is reducing. (IV) Practically demonstrate, in LAB, the simulated operations and results on scheduled day.

Required Results:
I. II. Plot the real and estimated step response on MATLAB and determine error in the estimated model, if any. Discuss your lab observations, results and give your results.

ASHAB MIRZA Lab Course In-charge

ST-22/C, Block-6, Gulshan-e-Iqbal, Karachi-75300, 021-99244218-20 34966274 Email: [email protected] Website: http://www.iiee.edu.pk www.ieee.org/iiee

You might also like