Scribd
Upload
31 views4 pages

Sambhram: Institute of Technology

This document appears to be a workshop diary from the Department of Mechanical Engineering at Sambhram Institute of Technology. It provides instructions and templates for students to document the process of creating various fitting models using different joint types, including semi-circular, rectangular, and dove-tail joints. The diary prompts students to provide details of the material used, tools, procedures, dimensions, and results of their models.

Uploaded by

Abhay Shankar Bharadwaj
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views4 pages

Sambhram: Institute of Technology

This document appears to be a workshop diary from the Department of Mechanical Engineering at Sambhram Institute of Technology. It provides instructions and templates for students to document the process of creating various fitting models using different joint types, including semi-circular, rectangular, and dove-tail joints. The diary prompts students to provide details of the material used, tools, procedures, dimensions, and results of their models.

Uploaded by

Abhay Shankar Bharadwaj
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

INSTITUTE OF TECHNOLOGY

SAMBHRAM
WORKSHOP DIARY

Name : .. Semester / Section : USN :..

DEPARTMENT OF MECHANICAL ENGINEERING


M.S.PALYA, Via. Jalahalli East, Bengaluru 560 097. Phone: 080-2364 3618, Fax: 080-2364 1701 www.sambhram.org

Given Material:

A
Finished Model:

A
Commencement Date:..

B
Date of Finishing:.

Description of Model

Tools Used 1) Bench vice

v-joint \ semi-circular \ rectangular \ dove-tail // butt \ lap \ T

2) Hack Saw 3) Centre Punch 4) Hammer 5) File(s) 6) Vernier Height Guage 7) Steel Ruler 8) Tri Square 9) Surface Plate

MODEL NUMBER: MODEL TYPE: (fitting / welding)

DATE:

JOINT TYPE: (v-joint, semi-circular, rectangular, dove-tail / butt, lap, T)

AIM: To obtain model OPERATIONS: filing, marking, punching, cutting, finishing. PROCEDURE: STEP 1: Fix the given work piece to the bench vice and file the adjacent edges using a flat file and check their perpendicularity using tri-square for both parts A & B. STEP 2: Apply a thin layer of wet chalk an the surfaces to be marked and allow it to dry. STEP 3: Mark the layout of given shape and dimensions on the work piece with the help of surface plate, angle plate and Vernier height gauge. STEP 4: With the help of the centre punch, mark the dots on the boundary line of the work piece. STEP 5: By having some allowance for cutting on the work piece, leave same space along the punched line. Mark it with a pencil for reference. STEP 6: With the help of an hacksaw, remove the unwanted material from both the work piece. STEP 7: With the help of suitable file(s) the filing is made onto the punch mark. STEP 8: The final fit is made according to the given dimensions. And over all finishing is done. RESULT: The required . model is obtained.

Semi-circular Joint:

A
Rectangular joint:

Dove-tail joint:

You might also like