Scribd
Upload
21 views

How To Measure Basic Tank: The Following Information Applies To: ALL DIVISIONS

This document provides instructions for measuring the key dimensions of a basic tank top for Abercrombie & Fitch, Abercrombie, and Hollister. It lists over 20 measurement points for the length, width, slope, armholes, neck, and trims. Measurements include the front and back length from the highest shoulder point, chest width, waist width and position, shoulder slope, armhole length and position, neck width and drop for front and back, and the heights of armhole, bottom, and neck trims.

Uploaded by

frodrez_931726
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
21 views

How To Measure Basic Tank: The Following Information Applies To: ALL DIVISIONS

This document provides instructions for measuring the key dimensions of a basic tank top for Abercrombie & Fitch, Abercrombie, and Hollister. It lists over 20 measurement points for the length, width, slope, armholes, neck, and trims. Measurements include the front and back length from the highest shoulder point, chest width, waist width and position, shoulder slope, armhole length and position, neck width and drop for front and back, and the heights of armhole, bottom, and neck trims.

Uploaded by

frodrez_931726
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ABERCROMBIE & FITCH abercrombie HOLLISTER Co.

How To Measure BASIC TANK


ALL DIVISIONS A&F / abercrombie / Hollister. See following pages for variations

*the following information applies to:

Length fm HSP: garment is flat, measure from natural shoulder fold. L09- Front length fm HSP (to bottom opening edge) L13- Side seam length (meas fm top of armhole trim to btm opening edge) Body width- measure all points horizontally across garment. *across shoulder, across front & across back should include trim* B01- Chest width- 1" below armhole B05- Waist Width B03- Waist position fm HSP (location of where to measure waist) B13-Bottom opening X07- Across shoulder X16- Across front _# fm HSP (meas dwn fm HSP, then across) X17- Across back _# fm HSP (not shown, meas same as XI6) Slope- place HSP on straight edge of table (Tank) measure down fm HSP to shoulder fold @ armhole edge. X0l-Shldr slope Armhole- position to measure armhole without causing distortion. A0l-Armhole Length- Straight (measure edge to edge) A03- Armhole - HSP to underarm point (vertically) to top of a/h trim. Neck- place HSP on straight edge of table N01- Neck Width- HSP to HSP (also known as seam to seam) N05- Front Neck Drop- HSP to seam

N06- Back Neck Drop- HSP to seam


N02- Neck Width- Edge to Edge N07- Front Neck Drop- HSP to edge N08- Back Neck Drop- HSP to edge
Trims-

A09- Armhole Trim Height Bll- Bottom Hem Height C03-Neck Trim Height @ CB

A03

measuring neck edge to edge

You might also like