Scribd
Upload
51 views

Notations Temperature Raise in Metal Working Process

The document provides notations and parameters for calculating temperature increases during a metal working process. It lists input parameters like material thickness, feed rate, diameters, and material properties. It then outlines the calculations to determine: 1) temperature rise without friction, 2) temperature rise with friction, 3) instantaneous temperature, 4) total temperature rise, and 5) temperature in degrees Celsius.

Uploaded by

Balu Zerofour
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
51 views

Notations Temperature Raise in Metal Working Process

The document provides notations and parameters for calculating temperature increases during a metal working process. It lists input parameters like material thickness, feed rate, diameters, and material properties. It then outlines the calculations to determine: 1) temperature rise without friction, 2) temperature rise with friction, 3) instantaneous temperature, 4) total temperature rise, and 5) temperature in degrees Celsius.

Uploaded by

Balu Zerofour
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 4

TEMPERATURE RAISE IN METAL WORKING PROCESS NOTATIONS FEED(m) f PASS INNER DIAMETER(m) ID PASS OUTER DIAMETER(m) OD THICKNESS OF PASS(m)

t PASS OUTGING INNER DIAMETER(m) ID INPUT PARAMETERS PASS OUTGOING OUTER DIAMETER(m) OD PASS OUTGOING THICKNESS(m) t LENGTH OF TUBE(m) L ELONGATION (e) e 2 AREA(m ) A NOTATIONS VELOCITY OF MATERIAL/TOOL INTERFACE(m/s) VOLUME SUBJECTED TO TEMPERATURE RAISE(m3) EFFECTIVE STRESS(pa) EFFECTIVE STRAIN DENSITY OF WORK PIECE(kg/m3) SPECIFIC HEAT(j/kg-k) FRACTION OF DEFORMATIONWORK CONVERTED TO HEAT TIME INTERVAL (sec) CO-EFFICIENT OF FRICTION() STRESS NORMAL TO INTERFACE (pa) DIE TEMPERATURE (k) INITIAL TEMPERATURE OF WORKPIECE (k) HEAT TRANSFER CO-EFFICIENT(w/m k) MATERIAL THICKNESS BETWEEN DIES (m) FINAL TEMPERATURE RAISE 1)TEMPERATURE RAISE WITHOUT FRICTION (k) CALCULATIONS 2)TEMPERATURE RAISE WITH FRICTION (k) 3) INSTANTANEOUS TEMPERATURE (k) 4) TOTAL TEMPERATURE RAISE (k) 5)TEMPERATURE IN DEGREES (0c)
2

V c
-

PARAMETERS

t T0 T1 h Td Tf T Tm Tm

0.0034 0.031 0.045 0.007 0.02395 0.03175 0.0031 0.44 2.87818E-05 0.000137817 9.78583E-08 0.004029 600000000 0.5 6520 502 0.95 180 0.1 55000000 323.14 300 1.28 0.00505 87.07501283 1.01248E-06 300.3203168 387.3953307 114.3953307

You might also like