Scribd
Upload
372 views

Job Safety Analysis

The document outlines the basic steps of a Job Safety Analysis (JSA) which includes selecting a job for analysis, breaking it down into steps, identifying potential hazards in each step, and determining corrective actions. It then provides an example of a JSA for slick line operations, listing the sequence of steps for two activities, the potential hazards of each step, and the corrective actions to address the hazards.

Uploaded by

HSE Eng
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
372 views

Job Safety Analysis

The document outlines the basic steps of a Job Safety Analysis (JSA) which includes selecting a job for analysis, breaking it down into steps, identifying potential hazards in each step, and determining corrective actions. It then provides an example of a JSA for slick line operations, listing the sequence of steps for two activities, the potential hazards of each step, and the corrective actions to address the hazards.

Uploaded by

HSE Eng
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Job safety Analysis: - It is procedure that helps to integrate health & safety

principles & practices of particular task or operation job.

What are four basic steps of JSA?

1. Select job for analysis.


2. Break job down into sequence of steps.
3. Identify potential hazards in each job.
4. Determine corrective action in each step.

Benefits of JSA:-

1. It can be considered as work procedure.


2. It can use in identify undetectable hazards.
3. Assist in completing incident investigation.
Main Activity: - Slick line Operation

# Sequence of steps Potential Hazards Corrective


Actions
1 Down hole & service Burn from high *Wearing full
operation during temperature of heat
steam injections well head & protection suit.
explosion or burn *Remote
from uncontrolled thermostats to
release of steam & measure
equipment temperature
breaking or wire before
damage entering the
area.
*Don’t exceed
60% of wire
strength
breaking.
2 Working in H2S Exposure to lethal *All CSG valve
existing area. concentration of in the vicinity
H2S gas. area should be
closed.
*Breathing
Apparatus
should be
available &
H2s personal
detector.

You might also like