Scribd
Upload
546 views

F-QC-02 (Insulation Test Report) TGTK HEADING

This document summarizes the insulation and high voltage test results for a low voltage switchgear cubicle. It provides the test results for phase to phase, phase to ground, and high voltage power frequency tests. All tests were deemed satisfactory as the insulation resistance met or exceeded the required 1000 ohms/volt minimum and there were no punctures or flashovers during voltage testing up to 2.5 kV for 1 minute. Environmental conditions like temperature and humidity were also recorded during testing.

Uploaded by

visanu
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
546 views

F-QC-02 (Insulation Test Report) TGTK HEADING

This document summarizes the insulation and high voltage test results for a low voltage switchgear cubicle. It provides the test results for phase to phase, phase to ground, and high voltage power frequency tests. All tests were deemed satisfactory as the insulation resistance met or exceeded the required 1000 ohms/volt minimum and there were no punctures or flashovers during voltage testing up to 2.5 kV for 1 minute. Environmental conditions like temperature and humidity were also recorded during testing.

Uploaded by

visanu
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

F-QC-02

TGTK
INSULATION AND HIGH VOLTAGE TEST REPORT

Customer Project Job No.

: : :

Cubicle No. : PRIMARY CIRCUITS Voltage test at 1 kV For 1 minute Low voltage switchgear ***
The test is deemed satisfactory if the insulation resistance between circuits and exposed conductive parts is at least 1000 /V per circuit referred to nominal voltage to earth of these circuit

TEST RESULTS PHASE - PHASE R-Y Y-B B-R R-N Y-N B-N

( MEGGER TEST ) Results Before Pass After


MW MW MW MW MW MW

Model BM11D,AVO Fail PHASE - GROUND R-G Y- G B-G N-G Results Before Pass After
MW MW MW MW

Fail

Voltage test

2.5

kV. For 1 minute C

***

The test is considered to have been passed if there is no puncture or flash-over.

Room Temperature :

Relative Humadity :

%
Model BIDDLE 230315-47

TEST RESULTS ( 50 Hz - POWER FREQUENCY HIGH VOLTAGE TEST )

PHASE

Results

Pass

Fail REMARKS

R -

Leakage current

mA.

v.

Applied voltage (test)

Y -

Leakage current

mA.

Rate voltage

B -

Leakage current

mA.

t.
1minute

Remark :

*** IEC 60439-1

Test by : Date :

Witnessed by : Date :

You might also like