Scribd
Upload
97 views

Method of Sections Method of Sections

The document discusses the method of sections for analyzing trusses. It involves imagining cutting a truss into sections with an imaginary cut line and applying equilibrium equations to each section. Key steps are to first determine support reactions, select a section to analyze using cuts that allow solving one unknown at a time, and apply the equations of equilibrium for the sum of forces in the x and y directions and the sum of moments to solve for unknown member forces. Examples are provided to demonstrate solving for member forces using the method of sections.

Uploaded by

hgnvcbvncbnb
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
97 views

Method of Sections Method of Sections

The document discusses the method of sections for analyzing trusses. It involves imagining cutting a truss into sections with an imaginary cut line and applying equilibrium equations to each section. Key steps are to first determine support reactions, select a section to analyze using cuts that allow solving one unknown at a time, and apply the equations of equilibrium for the sum of forces in the x and y directions and the sum of moments to solve for unknown member forces. Examples are provided to demonstrate solving for member forces using the method of sections.

Uploaded by

hgnvcbvncbnb
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CIVL 3121

Trusses - Method of Sections

1/2

Method of Sections
If the forces in only a few members of a truss are to be determined, the method of sections is generally the most appropriate analysis procedure. The method of sections consists of passing an imaginary line through the truss, cutting it into sections. Each imaginary section must be in equilibrium if the entire truss is in equilibrium.

Method of Sections
Procedure for analysis - the following is a procedure for analyzing a truss using the method of sections:
1. First, if necessary, determine the support reactions for the entire truss. Next, make a decision on how the truss should be cut into sections and draw the corresponding free-body diagrams. Try to apply the three equations of equilibrium such that simultaneous solution is not required. Moments should be summed about points that lie at the intersection of the lines of action of two unknown forces, so that the remaining force may be determined.

2.

3.

Method of Sections
Imagine cutting a structure into two sections about line 11

Method of Sections
Typically the section with the fewest forces or with section with the most convenient geometry is selected. In this example the left-hand side. Apply the three equations of equilibrium to the section.

Left side

Right side

If possible, attempt to develop an equation in just one unknown. Look for points where the lines of action of several forces are concurrent.

Method of Sections

Method of Sections
FBC = 67.5 k
Example: Determine the forces BC, BG, HG, and CG in the following truss.

0 0

FBC (20 ft.) 30k (20 ft.) 50k (15 ft.)

FHG (20 ft.) 30k (20 ft.) 50k (30 ft.) 40k (15 ft.)

FHG = -75 k

4 FHC 40k 50k 5

FHC = 12.5 k

FBC = 67.5 k (T)

FHG = 75 k (C)

FHC = 12.5 k (T)

CIVL 3121

Trusses - Method of Sections

2/2

Method of Sections
Example: Determine the forces BC, CG, and GF in the following truss.

Method of Sections
Example: Determine the forces in all bars of the truss

500 lb.
10 ft.

800 lb.
10 ft.

500 lb.

10 ft.

End of Trusses - Part 3

Any questions?

You might also like