Scribd
Upload
1K views

Infeed Module LED Significance

6 Infeed Modules 6. Description Relay contact ready signal NC contact no contact Relay contact for group signal I2t and motor overtemperature Pulse enable enable voltage enable voltage Set-up operation contactor energization, start Signaling contact, line contactor enable signal for internal line contactor Fig. 6-2 Interfaces, infeed module (UI module) or infeed / regenerative feedback module (16 to 55 kW I / R module)

Uploaded by

Said Boubker
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
1K views

Infeed Module LED Significance

6 Infeed Modules 6. Description Relay contact ready signal NC contact no contact Relay contact for group signal I2t and motor overtemperature Pulse enable enable voltage enable voltage Set-up operation contactor energization, start Signaling contact, line contactor enable signal for internal line contactor Fig. 6-2 Interfaces, infeed module (UI module) or infeed / regenerative feedback module (16 to 55 kW I / R module)

Uploaded by

Said Boubker
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

11.05 05.

01

6 Infeed Modules 6.1 Description

Relay contact Ready signal

NC contact NO contact

74 nc 73.2 73.1 nc 72 5.3 5.2 5.1 63 9 9 64 19 7 45 44 10 15 15 R 9 112 48 111 213 113 NS1 NS2 AS1 AS2

X111

Relay contact for group signal I2t and motor overtemperature Pulse enable Enable voltage Enable voltage Drive enable Reference potential for enable voltage P24 P15 N15 N24 M M RESET (R+term.15) Enable voltage Setup operation Contactor energization, start Signaling contact, line contactor Enable signal for internal line contactor Signaling contact, start inhibit (NC contact)

X121

X141

1) X161 1) X171 2) X172 LED displays X351

DC link power supply for buffering power failures External infeed for the electronics power supply External infeed for the electronics power supply External infeed for the electronics power supply

M500
P500 2U1 1U1 2V1 1V1 2W1 1W1

X181 1)

Equipment bus

P600 DC link connection


LED display Electronics power supply faulted red 5 V voltage red level faulted Unit ready yellow (DC link precharged) DC link red overvoltage

M600

Device is not ready, green no enable signal (term. 63, 64 or 48) red Line supply fault

1) Jumpers inserted when the equipment is supplied 2) For UI modules, there is no X172 U1 V1 W1 X131 PE

Line supply connection

Fig. 6-2

Interfaces, infeed module (UI module) or infeed/regenerative feedback module (16 to 55 kW I/R module)

Siemens AG 2008 All Rights Reserved SIMODRIVE 611 Configuration Manual (PJU) 05/2008 Edition

6-151

You might also like