Scribd
Upload
16 views1 page

10.0 1 - Hole Drill & Tap M3: Title Projection Sheet A4 First Published in RCM&E Magazine February / March 2012. 2:1

The document provides technical specifications for a carburettor barrel including general tolerances for decimal places between 0-3 places as well as angular tolerances of ±0.2°. It also lists the material as mild steel or brass, dimensions of 10.0mm, and a single 3mm hole to be drilled and tapped with an M3 thread.

Uploaded by

montyviadero
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views1 page

10.0 1 - Hole Drill & Tap M3: Title Projection Sheet A4 First Published in RCM&E Magazine February / March 2012. 2:1

The document provides technical specifications for a carburettor barrel including general tolerances for decimal places between 0-3 places as well as angular tolerances of ±0.2°. It also lists the material as mild steel or brass, dimensions of 10.0mm, and a single 3mm hole to be drilled and tapped with an M3 thread.

Uploaded by

montyviadero
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Section on A-A

Front Elevation
General Tolerance
0 Decimal Places 0.5mm
1 Decimal Places 0.2mm
2 Decimal Places 0.1mm
3 Decimal Places 0.05mm
Angular 0.2
A
Material - Mild Steel or Brass
Completed Carburettor
Barrel
10.0
1 - Hole Drill & Tap M3
A
Scale:-
Drawing Number
Drawn
Date
Title
Projection
Sheet A4
First published in RCM&E magazine February / March 2012.
The Whittaker Firefly .46 Alex Whittaker
2:1
WF46-0015
Carburettor Barrel
1 - Hole 3mm
1
2
.
6
9
.
4
5.7

You might also like