Scribd
Upload
31 views2 pages

VNSine On Sine Testing

VNSine on Sine TestingVNSine on Sine TestingVNSine on Sine Testing

Uploaded by

viluk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views2 pages

VNSine On Sine Testing

VNSine on Sine TestingVNSine on Sine TestingVNSine on Sine Testing

Uploaded by

viluk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Sine-on-Sine Testing

Running Sine-on-Sine tests in VibrationVIEW Jordan Van Baren

V-Note # 0005

Abstract
The Sine-on-Random VibrationVIEW software can be used to run the Sine-on-Sine Tests.

Question
A customer asked me if we could help him with a new spec that came to him for testing. The spec included Sine-on-Sine testing and he was wondering if he had the capability to do this testing. He was familiar with the Sine-on-Random and the Randomon-Random testing modes from Vibration Research, but was wondering if he could run a new spec which needed Sine-on-Sine with no Random background noise.

Answer
To do this type of testing, the controller must be enabled to run a Sine-on-Random test. The first step is to click New Test in the VibrationVIEW software. Then click on the option to run a Sine-onRandom Test. In the Schedule tab, enter the amount of time you wish the test to run as specified by the test spec. In the modifier section of the Schedule tab enter 0 and make the units G RMS.

Next, in the Table tab keep the default Breakpoint Table entered here.

VIBRATION RESEARCH CORPORATION 2385 Wilshere Drive Suite A Jenison Michigan USA 49428 Phone 616-669-3028 Fax 616-669-5337 www.vibrationresearch.com

Sine-on-Sine Testing Once this is complete, click on the S-o-R tab. Enter the Sine-on-Random tones that you want for this test. Verify that the Sine-on-Random mode checkbox is selected for this test at the top left.

V-Note # Error! Reference source not found.

Once these steps are completed you are ready to run your Sine-on-Sine test. Click the Apply Button and start the test. Also Note: the Sine-on-Random Parameters tab allows you to further edit the test settings for your Sine-on-Sine Test.

VIBRATION RESEARCH CORPORATION 2385 Wilshere Drive Suite A Jenison Michigan USA 49428 Phone 616-669-3028 Fax 616-669-5337 www.vibrationresearch.com

Page 2

You might also like