Scribd
Upload
10 views

EFY Amdin: 564 Days Ago

This document provides troubleshooting tips for an oscillator circuit built around transistors N1 and N2. It notes that the circuit will not work properly if the oscillator is not connected correctly. It instructs the reader to first check the frequency at pin 4 of N2 using an oscilloscope, which should be around 4.7Hz, and then vary potentiometers VR1 and VR2 to increase the frequency at pin 4 of N2.

Uploaded by

jainkamalkumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
10 views

EFY Amdin: 564 Days Ago

This document provides troubleshooting tips for an oscillator circuit built around transistors N1 and N2. It notes that the circuit will not work properly if the oscillator is not connected correctly. It instructs the reader to first check the frequency at pin 4 of N2 using an oscilloscope, which should be around 4.7Hz, and then vary potentiometers VR1 and VR2 to increase the frequency at pin 4 of N2.

Uploaded by

jainkamalkumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

EFY Amdin

564 days ago

The circuit is working well. Note that if oscillator circuit built around N1 and N2 is not connected properly or not working properly you will never get proper output. Check the frequency at pin 4 of N2 you should get around 4.7Hz. First check frequency at pin4 of N2. It should be around 4.7Hz. Vary VR1 and VR2 and check frequency at pin 4 of N2 from the oscilloscope Just vary VR1 and VR2 to increase the frequency at pin4 of N2.

http://www.datasheetcatalog.com/info_redirect/datasheet2/9/0paqd91zcls9g4akywgtgso3y1ky.pdf.sht ml

You might also like