Scribd
Upload
518 views

Electric Bell: Physical Structure

An electric bell uses a coil wound around an iron core to create a magnetic flux through the core and armature. When current flows through the coil windings, it creates a magnetic field that pulls the armature and attached clapper towards the electromagnet, causing the clapper to hit the bell. When the contacts open to stop the current, the magnetic field ceases and the spring-loaded armature returns to its original position to close the contacts and repeat the process.

Uploaded by

Muhammad Fitri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
518 views

Electric Bell: Physical Structure

An electric bell uses a coil wound around an iron core to create a magnetic flux through the core and armature. When current flows through the coil windings, it creates a magnetic field that pulls the armature and attached clapper towards the electromagnet, causing the clapper to hit the bell. When the contacts open to stop the current, the magnetic field ceases and the spring-loaded armature returns to its original position to close the contacts and repeat the process.

Uploaded by

Muhammad Fitri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 3

Electric Bell

FORWARD

Physical structure The coil are wound on an iron core to setting up magnetic flux through the core and an armature. The armature is supported by a flat spring fixed at the bottom end.

BACK

HOME FIRST SLIDE LAST SLIDE

Electric bell

Electric Bell
FORWARD

Operation

BACK

HOME FIRST SLIDE LAST SLIDE

When the contacts are closed, current flows through the two windings (this is called a horseshoe electromagnet). This creates magnetic flux that pulls the arm (called the clapper) towards the electromagnet.

Electric Bell
FORWARD

Operation The hammer hits the bell and at the same time the contacts are opened. This causes the current to stop flowing and the magnetic flux ceases (collapses). The arm is returned (via a small piece of springy wire at the pivot-point) to a position where the contacts are closed and the current flows again to repeat the action.

BACK

HOME FIRST SLIDE LAST SLIDE

You might also like