Scribd
Upload
32 views

Specifications and Formulas

The document outlines formulas for calculating the areas of different ductwork shapes, including straight ducts, elbows, tapers, offsets, shoes, and y-pieces and tee-pieces, with notes that if dimensions are in millimeters the calculated areas will be in square millimeters.

Uploaded by

almig200
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
32 views

Specifications and Formulas

The document outlines formulas for calculating the areas of different ductwork shapes, including straight ducts, elbows, tapers, offsets, shoes, and y-pieces and tee-pieces, with notes that if dimensions are in millimeters the calculated areas will be in square millimeters.

Uploaded by

almig200
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SPECIFICATIONS AND FORMULAS SPECIFICATION WIDTH HEIGHT LENGTH RADIUS DEGREE QTY OFFSET FORMULAS STRAIGHT FORMULA: (WIDTH

+ HEIGHT) X 2 X LENGTH x QTY = AREA ELBOW FORMULA (WIDTH + HEIGHT) X 2 X LENGTH X QTY = AREA LENGTH = (R+W/2) X 3.14 X (DEGREE/180) TAPER FORMULA:(WIDTH 1 + HEIGHT 1+WIDTH 2+ HEIGHT 2) X LENGTH x QTY = AREAIF UP/DOWN TAPER FORMULA:(WIDTH 1 + HEIGHT 1+WIDTH 2+ HEIGHT 2) X (LENGTH + OFFSET) x QTY = AREAOFFSET FORMULA:(WIDTH + HEIGHT) X 2 X (LENGTH + OFFSET) x QTY = AREASHOE FORMULA:(WIDTH + HEIGHT) X 2 X (LENGTH + 50 MM) x QTY = AREADUMMY:WIDTH X HEIGHT = AREAYEE PIECE FORMULA:STRAIGHT AREA + ELBOW AREA = AREATEE PIECE FORMULA:ELBOW AREA + ELBOW AREA = AREANOTE: IF ALL DIMENSIONS ARE IN MM, AREA IN SQ.MM

You might also like