This document provides installation instructions for Total Well Management (TWM) software and drivers for the Well Analyzer USB device on a Windows XP system. It outlines downloading TWM, uninstalling a previous version if present, installing TWM, installing the Well Analyzer USB driver using the Found New Hardware Wizard, and verifying the installation by checking the connection status in TWM.
This document provides installation instructions for Total Well Management (TWM) software and drivers for the Well Analyzer USB device on a Windows XP system. It outlines downloading TWM, uninstalling a previous version if present, installing TWM, installing the Well Analyzer USB driver using the Found New Hardware Wizard, and verifying the installation by checking the connection status in TWM.
ECHOMETER TWM and Well Analyzer USB Drivers: Installation Guide for Windows XP If you haven't already downloaded TWM, do so now. TWM Installation If your Well Analyzer is currently connected, turn the power off and disconnect it. Install the Total Well Management software. If the installer finds the 2008 version of TWM on your machine, it must be uninstalled first. Click "OK" to launch the uninstall process.
Then click "Yes" run the uninstall.
After uninstalling the 2008 version, the installation will continue as normal. Connect the Well Analyzer to the USB port of your computer and turn on the Well Analyzer power. Echometer Company 5001 Ditto Lane Wichita Falls, Texas 76302 U.S.A. Phone: (940) 767-4334 Fax: (940) 723-7507 E-Mail: [email protected]
Well Analyzer Driver Installation Windows XP uses a Found New Hardware Wizard to guide you through the installation process. When it appears, select the "No, not this time" option and click "Next".
Echometer Company 5001 Ditto Lane Wichita Falls, Texas 76302 U.S.A. Phone: (940) 767-4334 Fax: (940) 723-7507 E-Mail: [email protected]
On the next screen, "Install the software automatically" and click "Next".
The driver will be automatically installed. Click "Finish" to close the Wizard.
Well Analyzer Driver Verification Echometer Company 5001 Ditto Lane Wichita Falls, Texas 76302 U.S.A. Phone: (940) 767-4334 Fax: (940) 723-7507 E-Mail: [email protected]
Start TWM. Enter "Acquire Mode", select "Setup", and go to the "Equipment Check" tab. This screen displays the status of the connected Well Analyzer.
If the screen displays the message "UNABLE TO CONNECT TO WELL ANALYZER!", check settings. Click on the "Advanced Settings" button and select Well Analyzer Model E3. Echometer Company 5001 Ditto Lane Wichita Falls, Texas 76302 U.S.A. Phone: (940) 767-4334 Fax: (940) 723-7507 E-Mail: [email protected]