Scribd
Upload
265 views

Install

The document provides instructions for cracking PTC Creo Elements/Pro 5.0 software using a keygen file and patcher: 1. Open the ptc.dat file located in the crack directory and replace the host ID with your own. Run the keygen.bat file to generate a license.dat file. 2. Install Creo Elements/Pro and select locked licensing, pointing to the generated license.dat file. 3. Copy the patcher executable to the Creo install directory and run it to patch the software. 4. It is recommended to block Creo from internet access before running the cracked software.

Uploaded by

electronicssucks
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
265 views

Install

The document provides instructions for cracking PTC Creo Elements/Pro 5.0 software using a keygen file and patcher: 1. Open the ptc.dat file located in the crack directory and replace the host ID with your own. Run the keygen.bat file to generate a license.dat file. 2. Install Creo Elements/Pro and select locked licensing, pointing to the generated license.dat file. 3. Copy the patcher executable to the Creo install directory and run it to patch the software. 4. It is recommended to block Creo from internet access before running the cracked software.

Uploaded by

electronicssucks
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

_ _ _

_ __ _ ___ _____
_____ _____ ____

_

_ mg


:: <LEGENDS NEVER DiE>
PTC Creo Elements/Pro 5.0 M080
1. In the crack directory open the file called ptc.dat and 00-00-00-00-00-00 rep
lace with your
PTC host ID value (showed in left bottom corner of setup screen or use "Progr
am Files\PTC\Creo Elements\Pro5.0\bin\ptchostid.bat" to get it).
Run keygen.bat which will create a license.dat.

2. Run setup and install your selection of Creo products.
Select Locked licensing and point to license.dat created at step #1.
3. Copy the "PTC_Creo5_Corrector.exe" to "Program Files\PTC\"and run it. Patchin
g may need some minutes!
4. Before running Creo Elements it is strongly recommended to block it from inte
rnet access.
PS: You may run "Program Files\PTC\Creo Elements\Pro5.0\bin\ptcsetup.bat" to set
/change your WF5 setup.

You might also like