Scribd
Upload
50 views2 pages

Installation: Zoom Sized For Print

The document provides instructions for tightening cylinder head bolts during engine installation in 5 steps: 1) Tighten bolts in numerical order to specified torque, 2) Loosen all bolts completely, 3) Retighten bolts to specified torque, 4) Retighten bolts further to a specified angle using an angle wrench or marks on the bolts, 5) Set camshafts with dowel pins at the 12 o'clock position.

Uploaded by

Ronald Moon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
50 views2 pages

Installation: Zoom Sized For Print

The document provides instructions for tightening cylinder head bolts during engine installation in 5 steps: 1) Tighten bolts in numerical order to specified torque, 2) Loosen all bolts completely, 3) Retighten bolts to specified torque, 4) Retighten bolts further to a specified angle using an angle wrench or marks on the bolts, 5) Set camshafts with dowel pins at the 12 o'clock position.

Uploaded by

Ronald Moon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Installation

Zoom

Sized for Print


1. Tighten the cylinder head bolts in the numerical order as shown, using the five step procedure:

Zoom

Sized for Print



Cylinder head bolt tightening steps:
Step "a": 29 Nm (3.0 kg-m, 22 ft. lbs.)
Step "b": 79 Nm (8.1 kg-m, 59 ft. lbs.)
Step "c": Loosen all bolts completely.
Step "d": 25 - 34 Nm (2.5 - 3.5 kg-m, 18 - 25 ft. lbs.)
Step "e": 86- 91 degrees clockwise

NOTE: If an angle wrench is not available, mark all of the cylinder head bolts on the side facing engine
front. Then turn each cylinder head bolt to the specified angle.
2. Set camshafts and camshaft brackets.
Set the dowel pins of both the intake and exhaust camshafts at 12 o'clock position when
installing the camshafts.

Zoom

Sized for Print

You might also like