Scribd
Upload
400 views5 pages

Cancheck Programmer v1.0

The document provides instructions for disabling the CanCheck feature on Fiat Punto CD units with a 95320 EEPROM chip. It details locating and cleaning the EEPROM chip, clipping it with a data clip connected to a CanCheck programmer, and pressing a button to disable CanCheck before testing the radio.

Uploaded by

Anonymous OFfJVrQY6
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
400 views5 pages

Cancheck Programmer v1.0

The document provides instructions for disabling the CanCheck feature on Fiat Punto CD units with a 95320 EEPROM chip. It details locating and cleaning the EEPROM chip, clipping it with a data clip connected to a CanCheck programmer, and pressing a button to disable CanCheck before testing the radio.

Uploaded by

Anonymous OFfJVrQY6
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

1

Fiat Punto CD with 95320 EEPROM (Disable CanCheck)


(so far found to work on ALL Fiat units with 95320 EEPROM)

2

3

4

95320 EEPROM CanCheck Enable/Disable Programmer Operating Procedure
1) Strip the unit you wish to disable CanCheck on by removing the CD deck.
2) Using the above diagrams as a reference locate and clean (with a fibreglass brush) the 95320
EEPROM.
3) Clip the EEPROM with the supplied data-clip. Make sure the pin marked by red heat shrink on the
data-clip is nearest pin1 on the 95320 EEPROM. Pin1 on the EEPROM itself is the corner pin nearest
the ST logo. Refer to the above diagram for clarification.
4) Do not power the CD unit directly during the programming procedure! Power the CanCheck
programmer with a 12v centre positive (1 Amp will be more than adequate) PSU.
5) After 2 seconds the POWER led will light.
6) Press the BLUE CanCheck Disable button (or YELLOW CanCheck Enable button if that is what
you require), the BUSY led will light briefly and finally the OK led will also light briefly. CanCheck is
then disabled (or enabled if you pressed the YELLOW CanCheck Enable button). Remove the data-
clip and power the radio as shown below in order to test.
7) If there is any error during disabling or enabling CanCheck the ERROR led will light briefly.
5



2006 www.rampantapathy.co.uk DO NOT REPRODUCE ANY TEXT OR IMAGES WITHOUT PERMISSION

You might also like