Scribd
Upload
30 views

Design of T-Beam: Input Data

This document contains input data for the design of a T-beam including dimensions, material properties, and calculated values. It lists parameters like the length and width of the beam, concrete strength, steel yield strength, positive and negative bending moments, reinforcement diameters and areas. The summary provides calculations to check requirements for reinforcement areas and development lengths are satisfied for both positive and negative moments.

Uploaded by

Dodeptrai Bk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
30 views

Design of T-Beam: Input Data

This document contains input data for the design of a T-beam including dimensions, material properties, and calculated values. It lists parameters like the length and width of the beam, concrete strength, steel yield strength, positive and negative bending moments, reinforcement diameters and areas. The summary provides calculations to check requirements for reinforcement areas and development lengths are satisfied for both positive and negative moments.

Uploaded by

Dodeptrai Bk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

: .

: 24
:
:
:
input data cm 800
cm 20
cm 30
cm 300
cm 40
cm 4
cm 2.5
kg/cm2 250
kg/cm2 4200
ton.m 14.39
ton.m 19.96
mm 14
mm 14
mm 8
cm 200
cm 32.6
0.0018
cm2 11.91
mm 14 8
cm2 12.31
OK < As used (+ve) cm2 3.27
i) Check a<hf :-
OK cm 1.22 a
ii) Check Md>Mu
OK t.m 14.86 Md
0.0210
cm2 20.46
mm 14 14
cm2 21.54
OK < As used (+ve) cm2 5.88
Calaulate Value of a
cm 14.19 a
Check Md>Mu
OK t.m 20.73 Md

0598195411
Design of T-Beam
input data
Design By ENG.Mohammed AL-Saidy
Length of beam
Thickness of slab (hf)
Width of cross section (bw)
Total hight of section (h)
Factor bending moment Mu (+ve)
output data
Concrete cover
Factor bending moment Mu (-ve)
Dia. Of (-ve) reinforcement
Center-to-center-spacing of beams
Distance between layers
fc'
fy
Positive moment
Negative moment
Diameter of strip
(+ve)
be
d
As (+ve)
No. of bars for positive reinforcement
arranged in two layers
As used (+ve)
As (min)
1) For Positive moment
2) For Negative moment
Dia. Of (+ve) reinforcement
As used (-ve)
As (min)
(-ve)
As (-ve)
No. of bars for Negative reinforcement
moment diagram

You might also like