Scribd
Upload
29 views1 page

Standard Ductwork Sizes PDF

Recommended sizes correspond to the sizes stated in ISO 7807. Nominal diameters are given in Table 1. NOTE 315 mm. Pressed fittings are available in various forms and are normally limited to diameters not exceeding joints the overlap length of overlapping joints is given in Table 2.

Uploaded by

jambo_jones_94
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views1 page

Standard Ductwork Sizes PDF

Recommended sizes correspond to the sizes stated in ISO 7807. Nominal diameters are given in Table 1. NOTE 315 mm. Pressed fittings are available in various forms and are normally limited to diameters not exceeding joints the overlap length of overlapping joints is given in Table 2.

Uploaded by

jambo_jones_94
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EN 1506:2007 (E)

Table 1 Ducts with circular cross-section: dimensions


Nominal diameter,
d mm

Cross-sectional area, Ac
2
m

Duct surface area, Ai


2
m /m

Licensed copy:Edinburgh Telford College, 19/09/2014, Uncontrolled Copy, BSI

Recommended sizes
63
80
100
125
160
200
250
315
400
500
630
800
1000
1250

3,12 10
-3
5,03 10
-3
7,85 10
-3
12,3 10
-3
20,1 10
-3
31,4 10
-3
49,1 10
-3
77,9 10
0,126
0,196
0,312
0,503
0,785
1,23

-3

0,197
0,251
0,314
0,393
0,502
0,628
0,785
0,990
1,26
1,57
1,98
2,51
3,14
3,93

Additional sizes
150
300
355
450
560
710
900
1120

17,7 10
-3
70,7 10
-3
98,9 10
0,159
0,246
0,396
0,636
0,985

-3

0,471
0,943
1,11
1,41
1,76
2,23
2,83
3,52

NOTE Recommended sizes correspond to the sizes stated in ISO 7807.

5
5.1

Dimensions for fittings


General

The nominal diameters are given in Table 1.


NOTE
315 mm.

5.2

Pressed fittings are available in various forms and are normally limited to diameters not exceeding

Joints

The overlap length of overlapping joints is given in Table 2.

You might also like