Scribd
Upload
74 views

Tutorial 4 (Bolted and Welded Joints)

1. The document discusses bolted and welded joints used to connect structural components like brackets and plates. It provides details of four different joint configurations under applied loads and asks to determine minimum bolt sizes, maximum loads, and weld sizes based on allowable stress limits. 2. Key details include bolts connecting a crane bracket to a roof truss under tensile stress of 75MPa, bolts of 14mm diameter connecting a bracket under shear stress of 120MPa, parallel fillet welds joining plates with allowable shear per mm of 330N, and welds joining components under 7.5kN eccentric load with stress limit of 100MPa. 3. Dimensions of bolts

Uploaded by

Shaleen Chhabra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
74 views

Tutorial 4 (Bolted and Welded Joints)

1. The document discusses bolted and welded joints used to connect structural components like brackets and plates. It provides details of four different joint configurations under applied loads and asks to determine minimum bolt sizes, maximum loads, and weld sizes based on allowable stress limits. 2. Key details include bolts connecting a crane bracket to a roof truss under tensile stress of 75MPa, bolts of 14mm diameter connecting a bracket under shear stress of 120MPa, parallel fillet welds joining plates with allowable shear per mm of 330N, and welds joining components under 7.5kN eccentric load with stress limit of 100MPa. 3. Dimensions of bolts

Uploaded by

Shaleen Chhabra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Bolted and welded joints

j
1. A crane brack
ket is fasteneed to the roo
of truss by m
means of two identical boolts as shownn in
fiigure 1. Deteermine the siize of the bo
olts, if the tennsile stress inn the bolts m
must not exceed
75MPa.

2. How
H much ecccentric load
d P can be ap
pplied to the bracket, if tthe maximum
m shear stresss of
th
he bolt must not exceed 120MPa. Diiameter of thhe bolts = 144mm. Assum
me that entiree load
an
nd moment is
i equally sh
hared by the bolts.

T plates arre joined tog


gether by single transversse and doublle parallel fiillet welds ass
3. Two
sh
hown in figu
ure. The sizee of the fillett weld is 5m
mm and allow
wable shear lload per mm
m of
th
he weld is 33
30N. find thee length of each
e
parallel fillet weld.

4. A welded join
nt as shown in figure is subjected
s
to an eccentricc force of 7.55kN. Determ
mine
th
he size of thee welds if the permissiblle shear stresss for the weeld does not exceed 100M
MPa.

You might also like