Scribd
Upload
53 views

Individual Assignment 1 January 2012

The document provides instructions for an engineering drawing assignment involving drawing orthographic views and sectional views of various 3D objects from different angles. Students are asked to draw the front, top, and right side views of objects, as well as a sectional view cutting through a given plane, and to match sectional views to drawings.

Uploaded by

Fakhrul Razi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
53 views

Individual Assignment 1 January 2012

The document provides instructions for an engineering drawing assignment involving drawing orthographic views and sectional views of various 3D objects from different angles. Students are asked to draw the front, top, and right side views of objects, as well as a sectional view cutting through a given plane, and to match sectional views to drawings.

Uploaded by

Fakhrul Razi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

CCB 1052 Engineering Drawings January 2012

CHAPTER 1: TECHNICAL DRAWING


INDIVIDUAL ASSIGNMENT 1
Question 1
Draw the front, top and right-side orthographic views of the objects below on a
graph paper.

Figure 1.1
Question 2
I.

Sketch the following object, then draw the front, top and right-side
orthographic views of the object on a graph paper.

II.

Draw sectional view of cutting plane A-A.

CCB 1052 Engineering Drawings January 2012

Question 3
Match the correct sectional view for each five drawing.

You might also like