Scribd
Upload
470 views

Lab

The document describes a lab experiment to determine the amount of ascorbic acid in vitamin C tablets using titration with iodine solution, finding an average of 506 mg of ascorbic acid per tablet which is 101% of the labeled 500 mg amount and within USP guidelines of 90-110%. The objective was achieved through crushing and dissolving tablets, titrating samples with iodine, calculating ascorbic acid from titration volumes, and determining the percentage and pass of USP specifications.

Uploaded by

api-281862068
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
470 views

Lab

The document describes a lab experiment to determine the amount of ascorbic acid in vitamin C tablets using titration with iodine solution, finding an average of 506 mg of ascorbic acid per tablet which is 101% of the labeled 500 mg amount and within USP guidelines of 90-110%. The objective was achieved through crushing and dissolving tablets, titrating samples with iodine, calculating ascorbic acid from titration volumes, and determining the percentage and pass of USP specifications.

Uploaded by

api-281862068
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Lab #6- The Determination of Ascorbic Acid in Vitamin C Tablets

Lucus Turner
February 18, 2015

OBJECTIVE: The purpose of this experiment is to determine the amount of ascorbic


acid in Vitamin C tablets by titrating samples with 0.10 N iodine solution (the USP
method, and seeing if the final result yields within USP guidelines).

METHOD:
5 Vitamin C tablets
(C6H8O6)
Starch test solution
Retort stand

Carbon dioxide-free water

2 N Sulfuric acid (H2SO4)

0.1 N Iodine solution (I2)

3 250 mL Erlenmeyer
flasks
Burette clamp

50 mL Burette

Beakers

Mortar

Pestle

H2SO4- can cause severe damage to skin and clothing, wear eye protection. If in
contact, immediately wash the area with large amounts of water.

I2- can stain skin and clothing, if in contact, wash with plenty of water immediately.

For a full description of this experiment, refer to Chemistry 2131 Laboratory Manual,
experiment #6, The Determination of Ascorbic Acid in Vitamin C Tablets, p. 43.

The average weight of a single tablet was calculated using five tablets instead of
ten.

OBSERVATIONS: Vitamin C tablets used were Kirkland 500 mg and five tablets
were weighed out to be 0.6096 g, 0.6029 g, 0.5981 g, 0.6057 g, and 0.6025 g, with
the average of these five tablets coming to 0.6038g.

These tablets were crushed using a mortar and pestle and then weighed to
approximately 400 mg each (samples respectively being 409.2 mg, 402.2 mg, and
405.3 mg). Each of these samples were dissolved in a mixture of 100 mL carbon
dioxide-free water and 25 mL 2 N sulfuric acid in separate 250 mL Erlenmeyer
flasks.

The samples were than titrated at once with the 0.1 N iodine solution until the
yellow remained for a moment before disappearing once titration was stopped and
3 mL starch test solution was added. The titration was continued until the endpoint
(now a dirty purple because of the addition of starch test solution) was reached and
held for 90 seconds.

Table 6.1- Determination of Ascorbic Acid in Vitamin C Tablets

Sample 1
Sample 2
Sample 3

Initial Volume
(mL)
0.00 mL
0.35 mL
0.05 mL

Final Volume
(mL)
39.10 mL
38.20 mL
38.80 mL

Volume Dispensed
(mL)
39.10 mL
37.85 mL
38.75 mL

CALCULATIONS:
Amount of Ascorbic Acid in Each Sample
For each 1 mL of 0.1 N iodine solution titrated is equivalent to 8.806 mg of ascorbic
acid. This result is calculated by multiplying the amount of iodine solution titrated
into the sample by 8.806.

1) 39.10 mL x 8.806 mg
= 344.3146 mg
2) 333.3071 mg
3) 341.2325 mg

Determination of Ascorbic Acid per Tablet


The amount of ascorbic acid per tablet was calculated by a ratio of grams of
ascorbic acid in sample over grams of sample equaling amount of ascorbic acid per
table (the unknown variable) over the average weight of the five tablets.

1) 0.3443146 g =
x
0.4092 g
0.6038g
x= 0.3443146 g x 0.6038 g
0.4092 g
x= 0.5080576 g = 508.0576 mg
2) x= 500.3750 mg
3) x= 508.3548 mg

These amounts were than calculated to average 505.5958 mg, which can be round
to be 506 mg.

%Ascorbic Acid= 506 x 100


500
= 101.2%

DISCUSSION: The USP guidelines state that Vitamin C tablets must contain no less
than 90% and no more than 110% the labelled amount (Chemistry 2131 Laboratory
Manual), which in this experiment was 500 mg. In the lab it was calculated the
average amount of ascorbic acid in Kirkland Vitamin C tablets was 506 mg, falling at
101% in the tolerance which meets USP guidelines.

A possible source of error in this experiment was it was easy to over titrate past the
endpoint, possibly causing the calculations to be a bit inaccurate.

CONCLUSION: The purpose of this lab was to determine the amount of ascorbic
acid in Vitamin C tablets using the USP method, and to see if the final result fell
within USP guidelines. In this experiment, the average amount of ascorbic acid
calculated to be in Kirkland 500 mg Vitamin C tablets was 506 mg. This gives a
percentage of 101% which falls in USP guidelines as it does not exceed 110%
ascorbic acid.

POST LAB QUESTIONS:


1) (12 M) (1 mL) = (C2) (100 mL)
C2= (12 M) (1 mL)
(100 mL)
C2= 0.12 M
(0.12 M) (10 mL)= (C2) (100 mL)
C2= (0.12 M) (10 mL)
(100 mL)
C2= 0.012 M

(0.012 M) (1 mL)= (C2) (100 mL)


C2= (0.012 M) (1 mL)
(100 mL)
C2= 0.00012 M

0.0001 M
To prepare a 100 mL solution of 0.0001 M sulfuric acid from 12 M sulfuric acid
requires a serial dilution to obtain, in this case a 1/100 dilution followed by a
1/10 dilution, and then another 1/100 dilution. First, 1 mL of the stock 12 M is
pipetted into a 100 mL volumetric flask (a quarter to half full so water isnt
being directly added to acid) and then topped to the line with deionized water
and mixed. The new solution, with a concentration of 0.12 M, has 10 mL
pipetted into a 100 mL flask and then topped with deionized water. This
solution, 0.012 M, has 1 mL pipetted into a 100 mL volumetric flask and
topped to the line. This final solution is the 0.0001 M sulfuric acid.

REFERENCES:
White, J. (n.d.). Experiment #6- The Determination of Ascorbic Acid in Vitamin C
Tablets, Chemistry 2131 Laboratory Manual, p. 43.

You might also like