Scribd
Upload
49 views

The Objective of This Report Is To Characterise A Plate With A Hole When It Is Subjected Under Tension

The objective of this report is to characterize a plate with a hole subjected to tension using ADINA software. The plate has a thickness of 1mm. The report outlines the steps to set up the model, including defining geometry, boundary conditions, loads, materials and elements. Diagrams show the defined boundary conditions, loads, and generated elements. The theory section discusses stress analysis assumptions and stress concentration factors. The results section presents the maximum deformation of the plate and stress distribution from minimum to maximum values.

Uploaded by

marina890416
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
49 views

The Objective of This Report Is To Characterise A Plate With A Hole When It Is Subjected Under Tension

The objective of this report is to characterize a plate with a hole subjected to tension using ADINA software. The plate has a thickness of 1mm. The report outlines the steps to set up the model, including defining geometry, boundary conditions, loads, materials and elements. Diagrams show the defined boundary conditions, loads, and generated elements. The theory section discusses stress analysis assumptions and stress concentration factors. The results section presents the maximum deformation of the plate and stress distribution from minimum to maximum values.

Uploaded by

marina890416
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 10

OBJECTIVE

The objective of this report is to characterise a plate with a hole


when it is subjected under tension the results are analyzed using
the software ADINA. The plate has a thickness of 1mm. The
objective is to also demonstrate the body sheet feature of ADINA
M/MPS (the ADINA Molder, based on the Parasolid geometry
kernel). .

SET UP
These are the steps which guide you to complete problem 3

Invoking the AUI and choosing the finite element program.


Defining model control
Defining model geometry
Defining and applying boundary conditions
Defining and applying loads
Defining material

Define elements

DIAGRAMS

Fig1: Defining and aplying boundary conditions

Fig2: Defyning and applying Loads

Fig3: Defining he elements.

Fig4: Element generation

Fig 5: Resultant transformation

Theory

The main assumption made in the experiment is the stress


analysis which is limited to the linear elastic range and the
material is assumed to be linear elastic and isotropic. The stress
is a load divided by the area. Without the hole the nominal stress
would = Force/Area. The resulting stress concentration (SCF) is
given a maximum stress at hole over nominal stress based on
gross section.
SCF = Maximum Stress at Hole/ Nominal Stress Based on Gross
Cross-section.
The maximum stress adjacent at the hole is max = k net = K
(P/Anet) k is the stress concentration factor which is the size of
the bar and the diameter of the hole. Basically if you have a
smaller radius the results its higher stress.

Results

The results below show the simulation I got for the experiment i
did in ADINA.

Fig:6 maximum deformation of the plate.

Fig7:distribution of stress from the minimum to the maximum.

You might also like