Scribd
Upload
275 views2 pages

Exercise 1 (Isolation of Caffeine)

This document describes an experiment to isolate caffeine from tea leaves using extraction and distillation. Tea leaves are boiled in water to extract caffeine into the water. The water extract is then extracted with chloroform to transfer the caffeine into the organic solvent. The chloroform is distilled to remove it, leaving behind isolated caffeine crystals. The objectives are to gain experience in extraction, distillation, determining boiling points, and isolating chemicals from plants.

Uploaded by

Belle Anasario
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
275 views2 pages

Exercise 1 (Isolation of Caffeine)

This document describes an experiment to isolate caffeine from tea leaves using extraction and distillation. Tea leaves are boiled in water to extract caffeine into the water. The water extract is then extracted with chloroform to transfer the caffeine into the organic solvent. The chloroform is distilled to remove it, leaving behind isolated caffeine crystals. The objectives are to gain experience in extraction, distillation, determining boiling points, and isolating chemicals from plants.

Uploaded by

Belle Anasario
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

EXPERIMENT 1

ISOLATION OF CAFFEINE FROM TEA


I. OBJECTIVES
To gain experience in using extraction as a method of separation.
To assemble and use a simple distillation setup in the separation of volatile
substances from non-volatile materials.
To determine the boiling point of a liquid sample.
To isolate caffeine from tea and gain experience in chemical laboratory manipulation
of plant materials.

FIGURE 1: A simple distillation setup

II PROCEDURE
In this experiment, caffeine is isolated from tea leaves by preliminary extraction with water
followed by extraction into chloroform and removal of chloroform by evaporation.
A. Extraction
i. Solid -Liquid Extraction
a) Place 20.0 grams of tea, 12.5 grams of sodium carbonate and some boiling chips
in a 250-mL Erlenmeyer flask or 400-mL beaker covered with a watchglass.
b) Pour 175 mL of distilled water into the flask.
c) Heat the mixture and boil for 10 minutes.

d) Decant the liquid into a 250-mL Erlenmeyer flask


e) Cool the aqueous extract to room temperature.
i. Liquid-Liquid Extraction
a) Pour the cooled water extract into the separatory funnel.
b) Extract the solution with a 30 mL portion of chloroform. Take care not to shake the
funnel too vigorously, but shake it enough to make sure that caffeine is extracted
into the organic solvent.
c) Transfer the chloroform layer into a 125-mL Erlenmeyer flask.
d) Repeat steps 2 and 3 using another 30 mL chloroform.
e) Combine the two chloroform extracts.
f) Add a small amount of sodium sulfate to the pooled extract, and swirl the mixture for
a few seconds.
A. Distillation
i. Filter the chloroform extract through a cotton plug into a 250-mL distillation flask.
ii. Assemble a distillation setup as in Figure 1.
iii. Distill the chloroform and collect about 50 mL. (Take note of the Boiling Point Range).
iv.Transfer the remaining solution to a preweighed evaporating dish.
v. Evaporate the chloroform to dryness over a hot water bath.
vi.Cool the evaporating dish to room temperature and weigh.
vii.Collect the greenish-white crystals of caffeine and save for the next experiment.
III. QUESTIONS
A. Discuss briefly the role of the following in the isolation of caffeine:
i. sodium carbonate
ii. sodium sulfate
A. Give at least three characteristics of chloroform that make it a good extracting solvent for
caffeine.
B. How efficient is the extraction of tea leaves containing 1.0 g of caffeine with two 30-mL
portions of chloroform over that of a single step extraction (K25C = 8.36)?
C. What are emulsions? Why do they form during extractions? How are they minimized?
D. Why is it necessary to remove a stopper from a separatory funnel when liquid is being
drained from it through a stopcock.

You might also like