Scribd
Upload
250 views

Vibrating Screen Data Sheet

The document is a data sheet from FMC Technologies requesting information to design a vibrating screen for a customer. It requests details about the material to be screened such as size, capacity, characteristics. It also asks for specifications like power available, space for the screen, required size separations, and a sketch of the installation area. Providing this information will allow for correct recommendations for a vibrating screen to meet the customer's needs.

Uploaded by

Akhmad Audi Harvan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
250 views

Vibrating Screen Data Sheet

The document is a data sheet from FMC Technologies requesting information to design a vibrating screen for a customer. It requests details about the material to be screened such as size, capacity, characteristics. It also asks for specifications like power available, space for the screen, required size separations, and a sketch of the installation area. Providing this information will allow for correct recommendations for a vibrating screen to meet the customer's needs.

Uploaded by

Akhmad Audi Harvan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Vibrating Screen

Data Sheet

FMC Technologies, Inc.


2730 Hwy 145 South
Saltillo, MS 38866
P: 1.800.356.4899 P: 662.869.5711
F: 662.869.7405

Email: [email protected]

To assure correct recommendations, please furnish us with the following information:


1. Material
2. Capacity:

Temperature
Feed to screen

TPH

Momentary Peak

TPH

3. Size of largest pieces fed on screen


4. Weight per cu. Ft. (loose)
5. Characteristics of material:
(a) Bone dry

(b) Wet

(c) Granular

(d) Claylike

(e) Sticky

(f) Flaky

Give free moisture:

% Normal

% Maximum

6. Analysis of feed (Attach complete analysis; if this is impossible, give estimated or known percentage for each opening
at which separation is to be made; also for opening half the size of smallest separation).
% retained on

sq. opening

% retained on

sq. opening

% retained on

sq. opening

% retained on

sq. opening

% retained on

sq. opening

6A. What is percent of half size material? (Half size is the size you wish to screen at)
(Example: Screening at 1/4 , half size is 1/8)
)
7. Is screen to be used for (a) Scalping

(b) Sizing

(c) Dewatering

7A. Size separations required

Number of decks

8. What is the maximum size piece permitted through:


(a) Top deck

(b) Intermediate deck

9. What percent of fines can be tolerated in the oversize?


10. Power available: Motor RPM

Voltage

Phase

11. Method of feeding material to screen: Steady


12. Space available for screen: Height

(c) Bottom deck

Irregular
Width

Cycles
How fed
Length

13. GPM for wet screening:


IMPORTANT NOTE: Make rough sketch on reverse side of this sheet showing headroom, floor space, and desired
location of screen in relation to elevators or bins.
Date

Signed
Title

Company name and address


Contact Name:
Phone Number:
10211 02/17/10

Fax Number:

You might also like