Scribd
Upload
37 views

1.3.5 HSPA+ RRM Policy

The document discusses HSPA+ radio resource management policies, including admission control of streaming and best effort services as well as bandwidth of the Iub interface. It describes the discontinuous reception function that can be triggered by factors such as HSPA service initiation in an R99 cell or traffic. Load control policies for HSPA+ are similar to HSDPA and involve algorithms for light load reduction and overload control.

Uploaded by

Younes Blx
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
37 views

1.3.5 HSPA+ RRM Policy

The document discusses HSPA+ radio resource management policies, including admission control of streaming and best effort services as well as bandwidth of the Iub interface. It describes the discontinuous reception function that can be triggered by factors such as HSPA service initiation in an R99 cell or traffic. Load control policies for HSPA+ are similar to HSDPA and involve algorithms for light load reduction and overload control.

Uploaded by

Younes Blx
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

1.3.

5 HSPA+ RRM Policy


Similar to the RAN10.0, the HSPA+ admission control includes power admission control on
streaming and BE services and admission control of bandwidth of the Iub interface.
To support the enhancement function of the inter-frequency networking, the HSPA supports the
DRD function. The DRD function can be triggered by the following factors:
The HSPA service is initiated in cell R99.
Traffic
Retry timer
Access failure of the HSPA service
The load control policy of the HSPA+ is similar to that of the HSDPA.
LDR algorithm: If the usage of cell resources exceeds the basic congestion threshold, the cell
enters into the basic congestion state. In this case, the cell triggers the LDR to relieve the cell
resource congestion.
OLC algorithm: When the uplink or downlink power in an R99 cell exceeds the uplink or
downlink triggering threshold for OLC, the R99 cell enters into the overload congestion state. To
ensure the system stability, fast OLC actions are required to quickly eliminate the overload
congestion of the cell. If the uplink or downlink power of R99 cell is lower
Enhancement in the algorithm.
MOD CELLALGOSWITCH:
HspaPlusSwitch=64QAM-1&MIMO-1&L2ENHANCED-1;
4. The license supports the enabling of the switch of 21 Mbit/s and 28 Mbit/s (You can run
the DSP LICENSE command to check the switch configuration).
5. Run the following command to activate the corresponding HSPA+ cell:
ACT CELLHSDPA: CellId=0;
6. For the MIMO-enabled cell, run the ADD QUICKCELLSETUP command to set up a
local cell and run the MOD CELLSETUP command

You might also like