Scribd
Upload
3K views

Pipeline Hydrostatic Test Quality Control and Inspection Report Form

The report summarizes the cleaning, gauging, pressure testing and drying of a pipeline. It provides details of the pipeline section tested including size, material, design pressure and test pressures. It describes the test equipment used and calibration checks. It documents the cleaning process including water and inhibitor volumes and timelines. Gauging details pipe diameter and plate information. The pressure test date, durations, pressures and results are specified. Dewatering and drying details are also included, with sign off from quality control and inspection teams.

Uploaded by

mahesh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
3K views

Pipeline Hydrostatic Test Quality Control and Inspection Report Form

The report summarizes the cleaning, gauging, pressure testing and drying of a pipeline. It provides details of the pipeline section tested including size, material, design pressure and test pressures. It describes the test equipment used and calibration checks. It documents the cleaning process including water and inhibitor volumes and timelines. Gauging details pipe diameter and plate information. The pressure test date, durations, pressures and results are specified. Dewatering and drying details are also included, with sign off from quality control and inspection teams.

Uploaded by

mahesh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Project:

www.Inspection-for-Industry.com

Pipeline Hydrostatic Test Report


Cleaning, Gauging, Pressure Test & Drying
Pipeline

From:

to:

Client:
Contractor:
Ref. Standard:
Doc. No.:

Report No.:
Date:
Page 1 of 1

Attachment:

1.0 General Information


Test Section:
From Joint No./Sec.
to Joint No./Sec.
Test Section Length (m):
Line No./Test Section No.
Class (ANSI Rating):
Design Pressure (psi):
Location Class (Acc. to ANSI/ASME B31.8):
Design Factor:
Lowest point elevation:
Highest point elevation:
Pipeline Size (Diameter):
Pipe Material:
Wall Thickness:
High Point Vent(s) Installed
(Qty.
) Low Point Drain(s) Installed
(Qty.
Maximum Allowable Pressure at Lowest Point (psi):
Minimum Acceptable Test Pressure at Highest Point (psi):
2.0 Test Equipments
Air Compressor
Type:
Capacity:
Pressure Gauge:
Qty.
Capacity:
Calibration Checked
Recorder:
Calibration Checked
Dead Weight Tester:
Calibration Checked
3.0 Cleaning
Water Volume (m3):
Amount of Corrosion Inhibitor (if Applicable):
Launching Date/Time:
Receiving Date/Time:
Result:
Inspected By:

Sign.

4.0 Gauging
Pipeline Inside Diameter (Minimum):
Gauging Plate Material:
Launching Date/Time:
Result:

Gauging Plate Diameter:


Gauging Plate Thickness:
Receiving Date/Time:
Inspected By:

5.0 Pressure Test


Date/Time Test Started:
Minimum Test Pressure (psi):
Minimum Test Temperature (C):
Result:

Date/Time Test Finished:


Maximum Test Pressure (psi):
Maximum Test Temperature (C):

Sign.
(Duration:

Inspected By:

hr.)

Sign.

6.0 Dewatering & Draying


Dewatering Date/Time:

Dewatering Duration:

Quality Control
Name:
Sign:
Date

Drying Completed (Acceptable)

TPI Inspection
Name:
Sign:
Date

Client
Name:
Sign:
Date:

You might also like