Scribd
Upload
101 views1 page

Anchorbolt (318 08) Shear

This document provides calculations for the design of hairpin anchor reinforcement to replace concrete breakout strength per ACI 318-08 building code requirements for structural concrete. Input data includes the required anchor reinforcement strength, anchor bar size, reinforcing steel yield strength, concrete compressive strength, and spacing parameters. The results show the calculated development length and minimum required and provided anchor reinforcement areas to satisfy the design. The design is satisfactory.

Uploaded by

Anonymous xcFcOgMi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
101 views1 page

Anchorbolt (318 08) Shear

This document provides calculations for the design of hairpin anchor reinforcement to replace concrete breakout strength per ACI 318-08 building code requirements for structural concrete. Input data includes the required anchor reinforcement strength, anchor bar size, reinforcing steel yield strength, concrete compressive strength, and spacing parameters. The results show the calculated development length and minimum required and provided anchor reinforcement areas to satisfy the design. The design is satisfactory.

Uploaded by

Anonymous xcFcOgMi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SHEAR ANCHOR REINFORCEMENT

Per Building Code Requirements for Structural Concrete ( ACI 318-08)


Design of Hairpin Anchor Reinforcement in place of Concrete Breakout Strength
Job Name:
Subject:
Date:
7/29/2015 12:34
Job Number:
Originator:
Checker:
Input Data:
Req'd Anchor Reinf. Strength, V =
Anchor Reinforcement Size =
Reinforcing Yield Strength, fy =
Concrete Comp. Strength, f 'c =
Lightweight Concrete?
Epoxy Coated Bars?
Top Bar?
Ratio: As(required)/As(provided) =
Seismic Design per Chapter 21?
Center-to-Center Bar Spacing, bs =
Clear Cover to Face of Bar, bc =

9.5
3
60
4.0
No
No
Yes
0.80
No
12.00
2.00

kips
(dia. = 0.375'')

ksi
ksi

in.
in.

DESIGN SATISFACTORY
Results:
Development Length (Section 12.2 or 21.7.5):
Ld =
18.50 in.
Anchor Reinforcement Strength(Section D.6.2.9):
in2
As,min =
As,min = V/(0.75*fy)
0.21
As,prov =

0.22

in2

Comments:

C:\Users\yba\Downloads\ANCHORBOLT(318-08)

1 of 1

You might also like