Scribd
Upload
645 views

Casing Selection Burst and Collapse

This document discusses the process of selecting casing for wells based on burst and collapse pressures. It outlines plotting a graph with pressure on the y-axis and depth on the x-axis, then marking lines for collapse and burst pressures. Collapse lines are drawn from zero pressure at zero depth to the collapse pressure at casing shoe depth. Burst lines go from zero pressure at zero depth to the burst pressure at casing shoe depth. Available casing grades are then plotted on the graph and the casing selected must satisfy both collapse and burst pressures. Great care is needed when making the initial casing selection graph.

Uploaded by

zapspaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
645 views

Casing Selection Burst and Collapse

This document discusses the process of selecting casing for wells based on burst and collapse pressures. It outlines plotting a graph with pressure on the y-axis and depth on the x-axis, then marking lines for collapse and burst pressures. Collapse lines are drawn from zero pressure at zero depth to the collapse pressure at casing shoe depth. Burst lines go from zero pressure at zero depth to the burst pressure at casing shoe depth. Available casing grades are then plotted on the graph and the casing selected must satisfy both collapse and burst pressures. Great care is needed when making the initial casing selection graph.

Uploaded by

zapspaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

CASING SELECTION- BURST AND

COLLAPSE
admin | November 26, 2009 | Comments (0)
CASING SELECTION- BURST AND COLLAPSE
It is customary in casing design to define the load case for which the casing is designed for. There are several
load cases which arise due to drilling and production operations
However before a load case is applied, the casing grades/weights should initially be selected on the basis of
burst and collpase pressures, then load cases should be applied.If only one grade or one weight of casing is
available, then the task of selecting casing is easy. The strength properties of the casings available are compared
with the collapse and burst
pressures in the wellbore. If the design factors in collapse and burst are acceptable then all that remains is to
check the casing for tension. For deep wells or where more than one grade and weight are used, a graphical
method of
selecting casing is used as follows:
1. Plot a graph of pressure against depth, as shown in Figure 5.5, starting the depth and pressure scales at zero.
Mark the CSD on this graph.
2. Collapse Line: Mark point C1 at zero depth and point C2 at CSD. Draw a straight line through points C1 and
C2
For partial loss circulation, there will be three collapse points. Mark C1 at zero depth, C2 at depth (CSD-L) and
C3 at CSD. Draw two straight lines through these points.
4. Burst Line:Plot point B1 at zero depth and point B2 at CSD. Draw a straight line through point B1 and B2
(see Figure 5.5). For production casing, the highest pressure will be at casing shoe.
5. Plot the collapse and burst strength of the available casing, as shown in Figure 5.6. In this figure, two grades,
N80 and K55 are plotted to represent the available casing.
Select a casing string that satisfies both collapse and burst. Figure 5.6 provides the initial selection and in many
cases this selection differs very little from the final selection. Hence, great care must be exercised when
producing Figure 5.6.

You might also like