Scribd
Upload
431 views

V24-Tty Passive Manual

The document summarizes a passive RS232-TTY converter that allows communication between a PC and equipment with a 20mA interface, such as a Siemens Simatic S5 PLC. The converter uses optical coupling to galvanically separate the two signal directions and provide optimal hardware protection. To operate, the converter is plugged into the PLC and a free RS232 port on the PC. LEDs will flash to signal a data connection once the programming software establishes a link.

Uploaded by

Jair Pinho
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
431 views

V24-Tty Passive Manual

The document summarizes a passive RS232-TTY converter that allows communication between a PC and equipment with a 20mA interface, such as a Siemens Simatic S5 PLC. The converter uses optical coupling to galvanically separate the two signal directions and provide optimal hardware protection. To operate, the converter is plugged into the PLC and a free RS232 port on the PC. LEDs will flash to signal a data connection once the programming software establishes a link.

Uploaded by

Jair Pinho
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

V24-TTY-PASSIVE

www.horter.de

1. Introduction
The passive RS232-TTY converter (SWA-FG) makes the communication possible for your PC with equipment, this
one 20 disposes Pa interface of one, e.g. SIEMENS SIMATIC S5 SPS controls.
The serial transducer is used in a complete system. For this reason the norms applying to respective use case are
from technician, user and fitter to observe safety and accident prevention regulations absolutely. The operator is
responsible for the compliance with these regulations.
2. Function
The converter realizes the V24 signals of the RS232 interface of your PC in line current signals (TTY). For the
electronics in the converter a tension of 5 becomes V DC needs. Put this tension at the 15-pole programming
interface at the pin 14 (+5 V for SIMATIC S5 CPUs) and at the pin 15 of (GND).
Furthermore is a 20 ever needs mA signal for the reading and writing direction. These current sources lie to the pin
11 and 13 and flow against mass (GND). Two optical coupling devices which two signal directions galvanically
separate from the PC are internally built-in at our transducer. This offers optimal protection for your hardware.
3. Putting into operation
- Put the RS232-TTY converter on to the SIMATIC S5 CPU with the 15-pole plug. This is switched on the two
LEDs shine in the case and signal current conduction.
-

Put the 9-pole socket into a free RS232 interface at your PC now or use a suitable USB-RS232 adapter.

The LEDs flash and signal a data connection with that as soon as you build up a connection with your
programming software.

4. circuit diagram
SUB-D 15 Connector
Bridge between
Pin 152 und 6-11

(Nearer information and download http://www.horter.de/doku/)

5. Face plan
15-pole S5-PLC
Connection to PC

Bridge

6. Technical data
- supply voltage from SIMATIC-CPU 5V / 30mA
- Case measurements 72 x 50 x 21 mm

Horter & Kalb - Klinikumallee 23 - D-95445 Bayreuth Germany www.horter.de [email protected]

You might also like