Scribd
Upload
25 views2 pages

Design Problem 1: (Designproblem-Bonespring - PDF) (Design1-Data

1. The document provides data on a post-fracture treatment report, including tabulated slurry rate and pressure vs. time data and an attached well log, for evaluating a treatment on a well. 2. The evaluation requires determining the geometry of the fracture, efficiency of the treatment, and interpreting the results to discuss if the design was successful, needs improvement, or was a failure. 3. Relevant formation properties are provided, including porosity, permeability, and water saturation for different carbonate and sand layers in the Bone Spring formation, as well as reservoir temperature.

Uploaded by

HassaanAhmed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
25 views2 pages

Design Problem 1: (Designproblem-Bonespring - PDF) (Design1-Data

1. The document provides data on a post-fracture treatment report, including tabulated slurry rate and pressure vs. time data and an attached well log, for evaluating a treatment on a well. 2. The evaluation requires determining the geometry of the fracture, efficiency of the treatment, and interpreting the results to discuss if the design was successful, needs improvement, or was a failure. 3. Relevant formation properties are provided, including porosity, permeability, and water saturation for different carbonate and sand layers in the Bone Spring formation, as well as reservoir temperature.

Uploaded by

HassaanAhmed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Design problem 1

Given:
1. The post-fracture treatment report

(designproblem-

bonespring.pdf)

2. Tabulated STP, slurry rate and ppg vs time


3. Attached well log

(Design1-data.xls)

Evaluate the treatment on this well.


a. Determine the geometry of the frac
b. Determine the efficiency
c. Interpret the results and discuss if this design was
successful, needs improving or was a failure.

Bone Spring carbonate

= 10%, k = 0.1 md , Sw = 50%


= 15%, k = 0.2 md, Sw = 50%

perfs

Bone Spring sand

Tres = 117 F

You might also like