Scribd
Upload
623 views1 page

PPSC - Product Data Sheet Fusion Bonded Epoxy

Fusion bonded epoxy (FBE) is a powder coating suitable for application on pipelines for water, oil, and gas between 4.5-60 inches in diameter. It can withstand service temperatures up to 100°C when dry and 80°C when wet. FBE has been successfully used as a standalone coating for over 30 years and is also commonly used as the primary layer in multi-layer coating systems. It is applied by electrostatic spray to heated pipe and meets international standards for pipeline coatings.

Uploaded by

julianpirah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
623 views1 page

PPSC - Product Data Sheet Fusion Bonded Epoxy

Fusion bonded epoxy (FBE) is a powder coating suitable for application on pipelines for water, oil, and gas between 4.5-60 inches in diameter. It can withstand service temperatures up to 100°C when dry and 80°C when wet. FBE has been successfully used as a standalone coating for over 30 years and is also commonly used as the primary layer in multi-layer coating systems. It is applied by electrostatic spray to heated pipe and meets international standards for pipeline coatings.

Uploaded by

julianpirah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

 

Fusion Bonded Epoxy


Operating Conditions

FBE is a powder coating suitable for application to Water, Oil and


Gas pipelines of all diameters. Used for service temperatures up
to 100°C in dry conditions and a maximum of 80°C when wet.
Consult PPSC for guidance on use. FBE has been used successfully
as a standalone pipe coating system for over 30 years. FBE is also
the primary layer in many other coating systems such as 3 layer
polyethylene and 3 layer polypropylene systems.

Application and Standards

FBE is applied by electrostatic spray to the heated pipe. Wasco


Coatings applies FBE in accordance with recognized international
standards such as CSA Z245.20. NACE RP0394 etc, customer
specifications. Where required Wasco Coatings can provide details
of in house specifications for this product to help develop the
coating specification.

Typical Properties

Description Reference Standard Typical Value*

CSA-Z245.20-02 (12.8)
1.5 to 2.5
Cathodic Disbondment 24 hours,3.5V, 65°C
2.5 to 3.5
28days, 1.5V, 20°C
CSA-Z245.20-02 (12.14)
Adhesion Rating 1 or 2
75°C, 24 hours
Impact resistance CSA-Z245.20-02 (12.12) >3.0 J

Hardness Shore D ASTM D2240-97 Average 90


CSA-Z245.20-02 (12.11)
Flexibility Pass
3°/PPD @-30°C
Minimum Pipe Diameter 4.5”

Maximum Pipe Diameter 60”

Minimum Pipe Length 5.0 m

Maximum Pipe Length 24.4 m

Minimum Operating Temperature -40°C

Maximum Operating Temperature 100°C

*Typical values are quoted but may vary with as a result of surface treatments and materials used
 

You might also like