Scribd
Upload
268 views

MPC Fuser Reset

The document provides instructions for performing a push switch mod to reset the fuser counter on an MPC5502 printer. It involves entering the service program mode, navigating to a specific menu option, pressing and holding a switch while executing the option to simulate a fuse blowing, which will reset the fuser's page counter and make the printer think a new fuser is installed. Additional notes provide details on the timing of the reset and that the mod will work for refurbished or repaired fusers.

Uploaded by

Matías Casali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
268 views

MPC Fuser Reset

The document provides instructions for performing a push switch mod to reset the fuser counter on an MPC5502 printer. It involves entering the service program mode, navigating to a specific menu option, pressing and holding a switch while executing the option to simulate a fuse blowing, which will reset the fuser's page counter and make the printer think a new fuser is installed. Additional notes provide details on the timing of the reset and that the mod will work for refurbished or repaired fusers.

Uploaded by

Matías Casali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MPC5502 fuser reset

I can confirm the push switch mod works fine.

1. Fit the fuser, closed the side door and power on.
2. Enter SP mode and goto SP5810-002.
3. Before you tap execute push and hold the switch in.
4. Tap execute, now instead of a instant failed message there will an slight pause, this is when you let
the push switch out to simulate the fuse blow.

The PM counter for the fusing unit automatically resets when an new fusing unit is detected.

Additional notes
The machine does not appear to check the new fuser circuit until you tap on execute (SP 5810-002).
The 2 pin connector is present but empty on the original fuser that comes with the machine.

If you are fitting the ricoh part fuse to a refurbished or repaired fuser, the machine will think the fuser is
a brand new one. Insert fuser, 5810, done.

You might also like